Laserfiche WebLink
3.07 DELIVERY,STORAGE,AND HANDLING <br /> A. General: Follow procedures specified in Division 1 Section"Temporary Facilities". <br /> 1. Deliver products to the project properly identified with names, model numbers, types, grades, compliance <br /> labels,and other information needed for identification. <br /> 2. Storage of materials and equipment shall not impede the work of other contracts. <br /> 3. Protect all components of the mechanical installation from becoming fouled or otherwise damaged in storage. <br /> 4. Handling of equipment and products shall be according to manufacturers instructions and in compliance with <br /> the articles of their warranty. <br /> 5. Protect products from weather, unless product is slated for exterior installation. If outdoor storage is <br /> necessary,support products off the ground or pavement in watertight enclosures. <br /> 3.08 FIRE SAFETY PRECAUTIONS <br /> A. The Contractors shall exercise extreme care to maintain and exercise adequate fire safety precautions throughout the <br /> work. This shall include providing sufficient fire fighting devices, watchmen, standby helpers or other precautions <br /> during construction,in use of temporary heat,welding,brazing,sweating,testing or other phases of work. <br /> B. At all times,access shall be maintained for fire department trucks to the building. <br /> C. All welding brazing,cutting and sweating operations performed in vicinity of or accessible to combustible materials <br /> shall be adequately protected to make certain that sparks or hot slag does not reach the combustible material and <br /> start a fire. <br /> D. All glass, glazed materials and other finish, in the vicinity of welding, brazing and cutting, shall be masked by the <br /> Contractor performing the welding work. <br /> E. When necessary to do cutting,welding,brazing,sweating and similar work in vicinity of wood, in shafts, or vicinity <br /> of any combustible material (and the combustible material cannot be removed), the materials shall be adequately <br /> protected with fire resistant blankets or similar approved coverings. In addition, a helper shall be stationed nearby <br /> with proper fire extinguishers(provided by the Contractor performing the work)to guard against sparks and fire. <br /> F. Whenever combustible materials have been exposed to sparks, molten metal, hot slag or splatter, a person shall be <br /> kept at the place of work to make sure the smoldering fires have not been started. Whenever cutting or welding <br /> operations are carried on in a vertical pipe shaft, a person to act as a fire guard shall be employed to examine all <br /> floors below the point of cutting or welding. This fire guard shall be kept on duty after completion of work to guard <br /> against fires and shall examine each level after this time, prior to leaving. There shall be no exceptions to this <br /> requirement and failure to comply will be construed as negligence. <br /> 3.09 PERSONAL SAFETY REQUIREMENTS <br /> A. The Contractor shall be responsible for initiating, maintaining and supervising all safety precautions required in <br /> connection with his work, including regulations of the Occupational Safety and Health Administration(OSHA)and <br /> other governing agencies. <br /> 15010-5 No.99132-CP2 <br />