Laserfiche WebLink
E. High Strength Bolted Construction Assembly: Tighten in accordance with Section 5, reference "Specification for <br /> Structural Joints Using ASTM A325 or A490 bolts." <br /> ' F. Welded Construction: In accordance with"AWS"reference specification. <br /> G. Gas Cutting: Field correcting of fabrication by gas cutting is not permitted on members in the structural framing <br /> without prior approval of the Architect. <br /> H. Paint Touch-up: After erection of structural steel,touch-up paint field connections,bolt heads and nuts,welds and <br /> abrasions in the shop paint coating,with same paint used for shop painting. <br /> ' I. Repair galvanizing after completion of field welding according to ASTM A780. <br /> J. Install expansion bolts and adhesive anchors in strict accordance with manufacturer's instructions. <br /> 3.02 FIELD QUALITY CONTROL <br /> ' A. Special Structural Testing and Inspection <br /> 1. Special Structural Testing and Inspection and Conventional Testing and Inspection shall be performed by <br /> qualified parties as specified herein and in accordance with the provisions of Section 01410. <br /> ' 2. If special inspection of Fabricator's work is required, special inspector may test and inspect structural steel at <br /> plant before shipment. <br /> ' 3. Qualifying Agencies: <br /> a. A.S.N.T.: The American Society for Non-destructive Testing <br /> b. N.D.E: Non-destructive Evaluation <br /> ' C. A.W.S./C.A.W.I.: American Welding Society/Certified Associate Weld Inspector <br /> d. A.W.S./C.W.I.: American Welding Society/Certified Weld Inspector <br /> 4. Personnel Qualifications: <br /> a. Special Inspector - Technical: Shall be employed by a testing agency and shall be supervised by an <br /> ' A.W.S./C.W.I.with a minimum of 10 years experience or an A.S.N.T. Level III with a minimum of 10 <br /> years experience. Individuals shall satisfy the following requirements: <br /> 1.) Technical I: Non-destructive Testing Technician A.S.N.T.-TC-IA Level 1,and/or A.W.S./C.A.W.I. <br /> 2:), Technical II: Non-destructive Testing Technician A.S.N.T.-TC-IA Level II, (NDE Technician II), <br /> A.W.SJC.A.W.I.,with minimum 3 years experience,or an A.W.SJC.W.I. <br /> 3.) Technical III: A.S.N.T.Level III with a minimum of 10 years experience or an A.W.SJC.W.I.with <br /> a minimum of 10 years experience. <br /> 5. The Owner will provide the following tests and inspections: <br /> a. Test high strength bolted connections according to the requirements of R.C.S.C. "Specification for <br /> Structural Joints Using ASTM A325 or ASTM A490 Bolts",UBC Standard 27-7 and as follows: <br /> 1.) Preparation: Visually inspect mating surfaces and bolt type for all bolted connections for general <br /> ' conformance with the contract documents prior to bolting. Qualifications: Technical H. <br /> 05100-5 No.99132-CP2 <br />