Laserfiche WebLink
I • <br /> I <br /> f • Nail assembled side walls to floor using 16d nails. Nails should be <br /> � placed so as to be driven through the plate and into a joist or plate. <br /> ' Note: A loose stud marked "sfi:nger" may be used to support the side <br /> j walls temporarily until the front and rear walI framing is installed. (see fig. <br /> 2-3) <br /> I wall <br /> • naiis <br /> fioor <br /> • <br /> fiD. 2-3 <br /> 3. END WALLS INSTALLATION <br /> • Place unsided end wall sections between side walls, nail frames� to <br /> floor and side walls using 16d nails. Be sure to keep bottom plate tight <br /> to floor. �.p: place ugiy side of framing fa.cing out. <br /> • Front wall framing comes as a completed rectangle. Install as is. <br /> After installation of the front wall frame, carefully cut out the plate at <br /> the bottom of the door frame, and nail the piece removed to the <br /> underside of the door header. (see fig. 3-1) <br /> 2. move <br /> pc here <br /> 1. cut here <br /> fi�. 3-1 <br />