03-12-1984 Council Packet - Laserfiche WebLink

Home Browse Search

i 4.11.3 Shop Drawings shall be submitted according to the following schedule: (a) Three copies shall be submitted with reasonable r,romptness and in such sequence as to prevent delay cf the Work. (b) The Engineer shall, within fourteen (14) days cf tipsubmittal �1 of any Shop Drawings, return one copy to the Contractor mz;ieo� with corrections and changes. i (c) The Contractor shall then promptly correct the Shop Drawings to conform to the corrections and changes requested by the Engineer. 04 (d) Following completion of such corrections and changes, the Contractor shall prougtly furnish the Engineer two copies of the Shop Drawings conformin^ to the require.: corrections and changes. 4.11.4 Engineer will review with reasonable promptness Shop Drawings and samples, but Engineer's review shall be only for conformance with the design concept of the Project and for compliance with the informatics n given in the Cortract Documents and shall not- extend to means, methods, sequences, techniques or procedures of construction or to safety precautions or programs incident thereto. The review of a separate item as such will not indicate review of the assembly in which the item functions. Contractor shall make any corrections required by Engineer and shall return the required number of corrected copies of Shop Drawings and resubmit new samples for review. Contractor shall d .-ect specific attention in writing to revisions other than the corrections called .,r by ' Engin,�er on previous aubmittals. Contractor's stamp of approval on any Shop Drawing or sample shall constitute a representation to Owner and Engineer that Contractor has either determ4---d and verified all quantities, dimensions, field construction criteria, materials, catalog numbers, and similar data or assumes full responsibility for doing so, and that Contractor has reviewed or coordinated each Shop Drawing or simple with the requirements of the Work and the Contract Dor-rents. 4.11.5 Where a Shop Drawing or sample is required by the Specifications, no related -k shall be commenced until the submittal has been reviewed �.- and F- prove.. Engineer. 411.6 Engineer's reviee, or approval of Shop L rings or sam.nles shall not 04 relieve Contractor from responsibility for any deviations from the %A Contract Documents unless Contra: - has in writ4.ng called Engineer's attention to such deviation at the time or submission and Engineer has given written concurrence and approval to the specific deviation, nor -kid shall any concurrence or approval by Engineer re,'»ve Contractor from responsibility for errors or omissions in the Shop Draw:ngm. o± 4.12 QUALITY OF EQUIPMENT AND MATERIALS w 4.12.1 -n order to establish standards of quality, the Engineer, in the , Specifications, has referred to certain p,oduct,- 5y name and catalog s� - 10 - 352 6a 4/81