08-28-2023 Council Packet - Laserfiche WebLink

Home Browse Search

There shall be no exposed electrical cabling, harnesses, or terminal connections located in compartments, unless enclosed in an electrical junction box or covered with a removable electrical panel. Wiring shall be secured in place and protected against heat, liquid contaminants and damage. Low voltage overcurrent protective devices shall be provided for the electrical circuits. The devices shall be accessible and located in required terminal connection locations or weather resistant enclosures. Overcurrent protection devices shall be automatic reset type suitable for electrical equipment and meet SAE standards. All electrical equipment, switches, relays, terminals, and connectors shall have a direct current rating of 125 percent of maximum current for which the circuit is protected. Electro-magnetic interference suppression shall be provided in the system as required in applicable SAE standards. The electrical system shall include the following: Electrical terminals in weather exposed areas shall have a non-conductive grease or spray applied. All terminal plugs located outside of the cab or body shall be treated with a corrosion preventative compound. All electrical wiring shall be placed in a protective loom or be harnessed. Exposed connections shall be protected by heat shrink material and sealed connectors. Large fender washers shall be used when fastening equipment to the underside of the cab roof and all holes made in the roof shall be caulked with silicone. Electrical components installed in exposed areas shall be mounted in a manner that will not allow moisture to accumulate inside. A coil of wire must be provided behind an electrical appliance to allow them to be pulled away from mounting area for inspection and service work. All lights in a weather exposed area that have their sockets shall have corrosion preventative compound added to the socket terminal area. 100327.1 - ELECTRICAL HARNESS AND WIRING All wiring shall be hidden, enclosed, or protected under the body in protective material, or within the apparatus body components. In addition, split loom conduits shall be installed and enclosed, suitably secured and protected against heat and physical damage. 100091.1 - BATTERY SWITCH - MASTER DISCONNECT A rotary type master disconnect switch shall be provided in the cab within easy reach of the driver. The switch shall have a switch plate with Off/On label. There shall be a GREEN indicator light in the center console indicating the power is "ON". 100094.1 - BATTERY CHARGER AND 120 VOLT SHORE POWER RECEPTACLE A Kussmaul Autocharge 1000, Model 091-215-12, high output automatic battery charger shall be provided. The battery charger shall be wired to the 12 volt battery system. The unit shall be mounted in a clean, dry area accessible for service and/or maintenance. It shall be wired to the specified shore power receptacle. It shall include Model 091-194B-IND-WT-XX Digital Status Display Center. It shall also include Model 091-55-15-120 15 amp "auto-eject" shore power receptacle with hinged weatherproof cover and an enclosure for protection from dirt and damage. The shore power plug shall be "ejected" when the chassis' engine starter is engaged and the receptacle shall be wired to any 120 volt A/C equipment requiring shore power. Location shall be: Rear body panel, d/s Color of Digital Status Display Center and Auto Eject: Red Components wired hot: 100328.1 - DOT IDENTIFICATION LIGHTS All LED identification lights shall be installed on the vehicle as required by applicable highway regulations. 100329.1 - LICENSE PLATE MOUNTING An LED license plate light shall be installed on the rear vertical wall of the body. Skeeter Brush Trucks Page 15 07/21/2023