08-28-2023 Council Packet - Laserfiche WebLink

Home Browse Search

constructed of .125" aluminum on all exterior surfaces. The compartment shall be equipped with a hinged lift up aluminum door with a latch installed. There shall be a set of gas shocks installed on the lid of the tray to aid in opening and closing the tray in a safe manner. The compartment shall be equipped with Turtle Tile floor covering. The actual door opening shall be approximately 3" smaller in dimension. 204287.1 - SCBA BOTTLE STORAGE COMPARTMENT One (1) SCBA compartment shall be installed on the apparatus for storage of SCBA bottles. Qty: change Qty to desired amount of storage units. Location: To be determined by purchaser. 203941.1 - COMPARTMENT FLOORING Turtle Plastics Turtle Tile Compartment Matting shall be installed in all compartments and trays excluding the rear center under-body compartment. Turtle Tile shall be black in color and lock together design. More 100180.1 - REAR PULL OUT STEP There shall be a rear "Pull-Out-Fold-Down" step located at the driver's side rear of the apparatus, step shall be stowed in a pocket under the rear of the unit. Storage pocket shall be fabricated to allow easy access to deploying for operation. 100181.1 - FOLDING STEP A Signature 4 lighted 8" square folding step of die cast zinc shall be installed. The step shall comply with NFPA non-slip standards and shall be installed on the rear driver's side of the body. The step shall be equipped with lighting to NFPA standard. 100692.1 - SIDE BODY ACCESS STEPS There shall be a body access step assisting in access to top of the tool/hose trays from the side of the apparatus. It shall be a stirrup design, and be fabricated from 1" aluminum tubing. They shall be installed under the front of the body, one (1) each side. 100325.1 - ELECTRICAL ENCLOSURE An electric wiring enclosure for the 12 volt wiring shall be installed in the forward wall of the driver's side upper body compartment with an access panel. The dimensions of the enclosure shall be approximately 20" high, 14" wide, and 4" deep. 100326.1 - 12 VOLT ELECTRICAL SPECIFICATIONS The following describes the low voltage electrical system on the apparatus including all panels, electrical components, switches and relays, wiring harnesses and other electrical components. The apparatus manufacturer shall conform to the latest Federal DOT standards, current automotive electrical system standards and the applicable requirements of the NFPA. Wiring shall be stranded copper or copper alloy conductors of a gauge rated to carry 125 percent of the maximum current for which the circuit is protected. Voltage drops shall not exceed 10 percent in all wiring from the power source to the using device. The wiring, wiring harness and insulation shall be in conformance to applicable SAE and NFPA standards. The wiring harness shall conform to SAE J-1128 with GXL temperature properties. Exposed wiring shall be run in a loom with a minimum 289 degree Fahrenheit rating. Wiring looms shall be properly supported and attached to body members. Electrical conductors shall be constructed in accordance with applicable SAE standards, except when good engineering practice requires special construction. All wiring connections and terminations shall provide positive mechanical and electrical connections and be installed in accordance with the device manufacturer's instructions. When wiring passes through metal panels, electrical connections shall be secured with mechanical type fasteners and rubber grommets Wiring between cab and body shall be split using connectors or enclosed in a terminal junction panel allowing body removal with minimal impact on the apparatus electrical system. Connections shall be crimp-type with heat shrink tubing with insulated shanks to resist moisture and foreign debris such as grease and road grime. Weather resistant connectors shall be provided throughout the system. Electrical junction or terminal boxes shall be weather resistant and located away from water spray conditions. When required, automatic reset breakers and relays shall be housed in the main body junction panel. Skeeter Brush Trucks Page 14 07/21/2023