08-28-2023 Council Packet - Laserfiche WebLink

Home Browse Search

2.5" discharge pressure gauge start/stop control throttle control low oil pressure warning light tachometer (if so equipped) The pump enclosure shall be mounted at the rear of the body. 100265.1 - PUMP CONTROL PANEL ENCLOSURE A pump panel enclosure shall be installed. The enclosure shall be fabricated of .125" aluminum with a DA finish, bolted in place with a pump instrument panel installed. An engine and pump control panel shall be installed in the pump panel enclosure. The following shall be on the pump panel: 2.5" discharge pressure gauge start/stop control throttle control low oil pressure warning light The pump control panel shall be installed at the passenger's side rear corner of the body. 100267.1 - FUEL SYSTEM FROM CHASSIS FUEL TANK The fuel system for the auxiliary fire pump shall be plumbed from the chassis fuel system. There shall be a separate fuel pickup tube mounted in the chassis fuel tank specifically for a separate engine driven pump assembly. There shall be an electric fuel pump with spin on fuel filter and flexible fuel hose furnished between the chassis fuel tank and the auxiliary pump. 100256.1 - ELECTRIC START WIRING TO CHASSIS The 12 volt positive and negative cables shall be provided from the chassis battery to the fire pump area, wired through the master disconnect solenoid system. The cables shall have a circuit breaker installed at the chassis battery. 100474.1 - AUXILLIARY FIRE PUMP MOUNTING PROVISIONS The auxiliary fire pump shall be installed at the center rear of the body. The sub-structure shall have welded in mounting sub-plates between the structural members. 100254.1 - PUMP ENGINE OIL DRAIN The fire pump engine shall have an oil drain line installed. It shall allow for easy oil draining. 100253.1 - FIRE PUMP MASTER DRAIN The fire pump shall have a master drain at the bottom of the water pump housing. 100270.1 - 2-1/2" GATED INTAKE -- REAR One (1) 2-1/2" gated suction intake shall be installed on rear area to supply the fire pump from an external water supply. The valve shall be controlled with a direct quarter-turn ball valve control handle and shall have 2-1/2" NH female thread with removable screen with plug. 204245.1 - TANK TO PUMP LINE INSTALLATION The 2" tank to pump line shall be installed with a flexible hump hose connection and stainless steel clamps to the water tank. The valve shall be controlled with a manually operated handle directly on the valve. 100281.1 - WATER TANK FILL AND COOLING LINE One (1) 1" fire pump to water tank refill and bypass cooler line shall be provided. The pump to tank valve shall be a 1" full flow quarter turn ball valve with local control handle. A 1" flex hose shall be installed to the water tank. 100278.1 - 3/4" GARDEN HOSE DISCHARGE -- REAR One (1) .75" garden hose discharge shall be installed on the rear pump area, controlled by a quarter turn ball valve with local control handle. The discharge shall have a .75" male garden hose threads and cap. Skeeter Brush Trucks Page 8 07/21/2023