08-28-2023 Council Packet - Laserfiche WebLink

Home Browse Search

gauge, on/off ignition switch, and a low oil pressure light, engine choke, engine throttle Dimensions & Weight 36"L x 22"W x 26"H, 371lbs (168kg) Suction 2" NPTF Discharge (2) 1.5" NPTF or (1) 2.5" NPTF Documentation Pump Warranty/Guarantee to be included with each proposal. Pump warranty shall be for three (3) years. Additional details about the warranty can be found in the Skeeter user's manual of this vehicle. Engine Kubota D902 Diesel: 24 HP, liquid cooled, 12 volt starter, 40 amp alternator, replaceable fuel and oil pump filters There shall be an electric oil less primer assembly installed for the auxiliary fire pump. The electric primer assembly shall be capable of taking suction and discharging water with a lift of 10 feet in not more than 30 seconds with the pump dry, through 20 feet of suction hose of appropriate size. A vacuum test with a capped suction of at least 20' long shall develop 22" of vacuum and hold a vacuum with a drop not in excess of 10" in 5 minutes. Priming pump shall be activated by a mechanical/electric valve with a single pull control located at the pump operator's panel area. 100272.1 - STAINLESS STEEL PLUMBING SYSTEM The auxiliary fire pump plumbing system shall be built mostly of stainless steel piping, fittings, and connections. Victaulic couplings shall be installed to permit flexing of the plumbing system and allow for quick removal of piping or valves for service. Tank connections and remote plumbing shall use high-pressure flexible piping. Flexible hose couplings shall be threaded stainless steel or Victaulic connections. This shall include valves and hose threads. 100285.1 - VALVES All valves used in the plumbing installation shall be stainless steel quarter turn full flow type. The plumbing installation shall include quarter turn ball valves with local "on-valve" handle control, with custom embossed labeling for each valve. 100483.1 - HOSE THREADS The hose threads shall be National Hose Standard (NH) on all base threads on the apparatus intakes and discharges, unless otherwise specified. 100263.1 - EXHAUST SYSTEM The auxiliary fire pump and engine assembly shall have a muffler and vertical exhaust pipe. The exhaust pipe shall be directed upward and away from the pump operator. A rain cap will be installed on the vertical exhaust outlet. 100307.1 - PRIMER ASSEMBLY There shall be an electric oil less primer assembly installed for the auxiliary fire pump. The electric primer assembly shall be capable of taking suction and discharging water with a lift of 10 feet in not more than 30 seconds with the pump dry, through 20 feet of suction hose of appropriate size. A vacuum test with a capped suction of at least 20' long shall develop 22" of vacuum and hold a vacuum with a drop not in excess of 10" in 5 minutes. Priming pump shall be activated by a mechanical/electric valve with a single pull control located at the pump operator's panel area. 100266.1 - FIRE PUMP ENCLOSURE The fire pump house shall be installed around the pump and engine. The enclosure shall be fabricated of .125" aluminum. Hinged doors and access panels shall be installed for servicing of the engine. If so equipped, the engine and pump control panel shall be provided at the rear of the vehicle. The following shall be located at the operator's position: Skeeter Brush Trucks Page 7 07/21/2023