2002-P04953 - re-roof - Laserfiche WebLink

Home Browse Search

7� 4. RE-ROOFING OVER SHAKE PROCEDURE No. 11 INSTALLING RIDGE AND RAKE CUT PANELS RIDGEM O Rf Po//VT O MEASURE POINT UPTURN BEND UNE BEND LINE 2"UPTURN (50MP4 •� CUT UNE PURPOSE To provide a custom-fitted panel to the last course at the ridge and to the rake edge. ® ALWAYS BEND the ridge cut panels PROCEDURE first, then cut off the excess along the D) Be careful not to push the back of the previously marked cut line. Use the Gerard ridge cut panel down. The ridge cut panel The short course at the ridge and the full panel bender attachment.(See 111.) must be in the same plane as the rest of sections at the rake need to be measured, the roof. Nail the ridge cut through the 2' cut,and bent to fit. After all ridge panels are cut and bent, (50 mm)tum-up. RIDGE CUT PANEL install them as follows: O To obtain the bend line, measure the E) At hips and rakes,the ridge cut panel is distance from the back lip of the panel A) Position the ridge cut panel in place. turned up the same as the full panels. At already laid to the ridge board. This is Starting at one end of the ridge,nail the left valleys,the ridge cut panel is turned down. usually taken at the same point where the or right side first. nail penetrates the panel. Deduct 1h'(12.5 A Always deduct 112" (125 mm) from mm) from the measurement taken and B)Nail the other end by bowing the panel ridge panel measurements. This will record. up in the center to make it line up with the allow ridges to fit Shake panels are cut ' ®Apply measurements to full panels,mark panel beneath. & bent in the same manner as for tile. the full panel at both ends. To obtain the C) The middle of the panel can now be (Continued) cut line, scribe a line 2' (50 mm) past the nailed, in the same pattern used on field bend line. panels. 0 Gerard Roofing Technologies,2001-03-01 Page 45 M.3 GERAR[r