Project manual for the Orangery-1994

Home Browse Search

PART 1 DIVISION 6- WOOD Nelson Orangery 9415.00 October 3, 1994 2 4. Rough Hardware and Fasteners: Hardware shall be of commercial quality of type and sizes required to suit conditions or as designated on the Drawings. (a) All nails,screws, and hardware exposed to the we shall be double hot-dipped galvanized,zinc coated,or stainless steel. All fascia,trim, siding, and exterior boards are to be nailed with ringshank type"Stormguard"nails manufactured by W.H. Maze Company. (NOTE: Use"Split-less"nails for boards, trim,and fascia.) (b) All joist hangers, angles,brackets, and connections are to be manufactured by Simpson Strong Tie Company or equal approved by Architect. All connectors shall be located as shown on the Drawings, installed according to the manufacturer's recommendations to yield maximum pint strength,and shall conform to ASTM 1 S26, latest revision. (c) All concrete anchors shall be by the Rawlplug Company, 200 Petersville Road, New Rochelle, New York 10802 (912) 235-6300. Use"Rawl-Stud"anchors. 5. Structural Glue: All gluing of structural members shall be done with 3M#5230, strictly according to the manufacturer's recommendations. 6. Exterior Wall Sheathing: Sheathing shall be 1/2 inch APA-CDX plywood. Plywood shall be nailed at 6 inches on center along panel edges and at 12 inches on center along intermediate supports with 8d common nails. 7. Flat Roof Sheathing: Sheathing shall be3/4 inch thick APAA Sturdi-Floor Int/Ext 48/24 with exterior glue. Nail with 8d Ring Shark nails at 6"on center along panel edges and at 10" along intermediate supports. Glue all sheathing continuously along all supports. 8. Sill Seal: Sealant shall be Dow"Ethafoam"sill sealer. Install between all plates and wood studs in contact with masonry or concrete. 9. Interior Walls: Framing shall be constructed of 2 x 4 wood studs at 16 inches on center, unless noted otherwise. C. EXECUTION 1. All lumber and woodwork must be covered, protected, properly ventilated, supported above ground on level runners, and prevented from warping. 2. Install wood blocking(2 x 6 minimum size)at stud walls for the support of cabinets,toilet accessories, equipment, shelving, etc. and also where specifically shown on the Drawings. 3. Install wood blocking as shown on the Drawings and as follows: (a) Install all other blocking required for gypsum wallboard(minimum 16 inches on center) interior wall support and all other locations as necessary for secure and sound construction. (b) Install all solid wood fire blocking required by code. 4. All framing shall be coordinated with the location of plumbing pipes, heating ducts, and electrical wiring to avoid cutting structural members. The cutting of structural members may, in some cases,be approved only with prior approval of the Architect. 5. Install roof sheathing plywood with the long dimension perpendicular to the supports and with the end joints staggered 4'-0". 6. The Contractor is responsible for the correction of minor deviations in the existing framing by furring and shimming so that all finish materials are plumb,straight, and level.