Laserfiche WebLink
movement of the panel across adjacent panel in the direction indicated. <br /> 3. Security Foot Bolt: Provide security foot-operated dead bolt attached to the bottom rail of <br /> movable door panels to lock the panel when fully closed and when partially open to <br /> permit ventilation. <br /> 2.4 FABRICATION <br /> A. General: Fabricate wood sliding glass door units to comply with indicated standards. Include a <br /> complete system to assemble components and anchor units. <br /> 1. Provide units that are reglazable without dismantling panel framing. <br /> B. Assembly: Assemble components into complete weathertight units with flush,rigid,and hairline <br /> joints. Mill,cope,butt,and miter joints;secure by mechanical devices or other means to ensure <br /> permanently watertight joints. Provide at least two corrosion-resistant,prelubricated or self-lubricating <br /> rollers for each sliding panel,of sufficient capacity to ensure easy,quiet,and smooth operation. <br /> C. Weatherstripping: Provide operable panels with a double row of sliding weatherstripping in <br /> horizontal rails and single-or double-row weatherstripping in meeting or jamb stiles,as required to meet <br /> specified performance requirements. Provide compression-type weatherstripping at the perimeter of each <br /> movable panel where sliding-type weatherstripping is not appropriate. <br /> D. Preglazed Fabrication: Glaze wood sliding glass door units in the factory where practical and <br /> possible for the applications indicated. Comply with requirements of the Division 8 Section "Glazing" <br /> and NWWDA I.S.3. <br /> E. Screens: Provide insect screen unit for each operable panel. Design door units and hardware to <br /> accommodate screens in a tight-fitting removable amangement,on either inside or outside of door unit, <br /> with a minimum of exposed fasteners and latches. <br /> 2.5 FINISI3ES <br /> A. Wood Door Finish: Provide the following finish on exposed wood in door units: <br /> 1 Shop-Primed Units: Provide the fabricator's standard shop-prime coat on exterior wood <br /> surfaces only. Comply with requirements of the Division 9 Section"Painting"for prime <br /> paint. <br /> 2. Shop-Finished Units: Provide fabricator's standard shop fmish,consisting of prime coat <br /> and two coats of alkyd semigloss enamel totaling 3 mils dry film thickness applied to both <br /> exterior and interior wood surfaces. <br /> a. Color. White. <br /> PART 3-EXECUTION <br /> 31 INSPECTION <br /> A. Inspect openings before beginning wood sliding glass door installation. Verify that the rough or <br /> masonry opening is correct and that the sill plate is level. Do not install door units until unsatisfactory <br /> conditions have been conected. <br /> 1. Wood frame walis shail be dry,clean,sound and well-nailed,free of voids,and without <br /> offsets at joints. Ensure that nail heads are driven flush with surfaces in the opening and <br /> within 3 inches of the opening. <br /> Page 5 of 6 <br />