Arch/Structural specs for cabana,pool,hot tub areas

Home Browse Search

� Where the phrase"or equal"occurs in the Contract Documents,do not assume that the materials, � equipment,or other methods will be approved as equal unless the item has been specifically so approved for this Work by the Architect ' Product Handling:Comply with the manufacturer's recommendation on product handling,storage and prote�tion.Deliver products to the job site in thezr original containers,with labels intact and legible. All material shall be stored off the�rottnd,under waterproof en-closnres, and away&om wet or damp � surfaces. Maintain all finished surfaces clean and unmarred,and suitably protected untii accepted by Owner. � 01700 PROJECT CLOSEUUT Generat: ' When the various cor►struction Work is within fifteen(1 S)days of completion,the various Contractors shall give wiitten notice to the Archi#ect of date of substant�al completion and ready for pre-fin�al � inspection. Ali Subcontractors shall take action required to correct all deficiencies listed and when they have been completed,a final inspection will be made. ' U on com letion of final ins ection the Architeet eatt state that tbe ro'ect is com lete,or if work p P P P J P remains that a sutm,satisfactory to inseu'e the performance of the work, be retained until completion. ' When project is approaching completion and final payment,all Sub-Contractors shali secure lien wavers in full for labor and materiai furnislted itom a31 suppliers. Inadequa.te,in.complete,or insufficient wavers � shall constitute cause for non-approval ef fmal application for payments. Project record documents: � Throughout progress of the Work,each Contractor will maintain an accurate record of changes in the Conh�act Documents. Mgintain one complete set of the Contract Documents on the Site,to i�e used only � as the"Job Record Set". Do not use tlne 7ob Record Set for any purpase other than to record changes occurring in the Contract � Documents during the progress of the Work. Make entries within 24 hours after receipt of information that the change has occurned. Upon completion of the Work,and as a condition of its acceptance,deliver the properly annotated 7ob Record Set to the Architec� � 010740 WA�RRANTIES � Each Contractor shall be responsible for its own work and shall repair or replace(a#its own expenss)any defective work or material which may show itself within one year after issuance of Certif cate of Final Completion by the Owner. , END OF DMSION 1 -GENERAL REQUIREMENTS � � � SUMMARY OF WORK Page 5 of 5 GENERAL REQUIREMENTS