Laserfiche WebLink
+���,�9�� <br /> �� <br /> MINNESOTA DEPARTMENT OF LABOR AND INDUSTRY iJ�1`,r � <br /> Division of Construction Codes and Licensing ' " �t��� <br /> REPORT ON PLANS C/j�, <br /> O,� <br /> �,.6.o�v <br /> Plans and specifications on plumbing: Aladdin, 2377 Shadywood Road, Orono,Hennepin County,Minnesota, � <br /> Plan No. 100929 <br /> OWNERSHIP: Aladdin,Inc., 2377 Shadywood Road,Orono,Minnesota 55391 <br /> SUBMITTER(S): Center Point Plumbing LLC, c/o Mr. James L. Cote,20129 Wolverine Street NW,Elk River, <br /> Minnesota 55330 <br /> Plans Dated: <br /> Date Received: December 17,2009 <br /> Date Reviewed: December 30, 2009 <br /> SCOPE: This review is limited to the design of this particular project only insofar as the provisions of the <br /> Minnesota Plumbing Code, as amended,apply, and does not cover the water supply or sewerage system to which <br /> this plumbing system is connected. The review is based upon the supposition that the data on which the design is <br /> based are correct,and that necessary legal authority has been obtained to construct the project. The <br /> responsibility for the design of structural features and the efficiency of equipment must be taken by the project <br /> designer. Approval is contingent upon satisfactory disposition of any requirements included in this report. <br /> Special care should be taken to insure that the material and installation of the plumbing system are in accordance <br /> with the provisions of the Minnesota Plumbing Code. A copy of the approved plans and specifications should <br /> be retained at the project location for fnture reference. <br /> A set of the identified plans and specifications is being returned to Center Point Plumbing LLC. <br /> INSPECTIONS: All plumbing installations must be tested and inspected in accordance with the requirements of <br /> the Minnesota Plumbing Code. As specified in Minnesota Rules,part 4715.2830,no plumbing work may be <br /> covered prior to completing the required tests and inspections. Provisions must be made for applying an air test <br /> at the time of the roughing-in inspection as outlined in Minnesota Rules,part 4715.2820, subpart 2, of the code. <br /> A manometer test, as specified in Minnesota Rules,part 4715.2820, subpart 3,is required at the time of the <br /> finished plumbing inspection. It is the responsibility of the contractor/installer to notify the Minnesota <br /> Department of Labor and Industry when an installation for a state contract job,licensed facility, or project in an <br /> � area where there is no local administrative authority is ready for an inspection and test. To schedule inspections, <br /> contact the state plumbing standazds representative for your region,or call Jim Peterson at 651/284-5889. <br /> REQiTIItEMENT(S): <br /> I. The new sink shall not connect to the vertical riser serving the three-comparhnent sink as is currently <br /> shown. Since a tell-tale floor drain is required on the three-compartment sink's dedicated fixture branch,the <br /> floor drain must specifically serve that sink prior to connecting to any other fixtures (see Minnesota Rules, <br /> part 4715.1390, subpart 2). <br /> 2. A three-compartment sink, a hand sink, and a floor drain total7 drainage fixture units and are shown <br /> discharging through a 2 inch pipe. Since a 2 inch horizontal drain can only accommodate 6 fixture units at a <br /> slope of 1/4-inch per foot,this portion of the system is undersized(see Minnesota Rules,part 4715.2310, <br /> subpart 2). <br /> 3. It is recommended that a cleanout be provided where new waste and vent piping connects with existing <br /> plumbing to facilitate required testing of the new installation. <br /> 4. Verify that the existing water supply and waste systems are sized to accommodate the added fixtures(see <br /> Minnesota Rules,part 4715.3800 and part 4715.2310). <br />