2004-P07207 - new structure - Laserfiche WebLink

Home Browse Search

10/3.1/2017 04:36 FAX Zoos [ ) I Joints,penetrations,and all other such openings in the building envelope that are sources of air I leakage must be sealed. [ J Recessed lights must be 1)Type IC rated,or 2)installed inside an appropriate air-tight assembly with a 0.5"clearance from combustible materials.If non-IC sated,the fixture must be installed with a 3"clearance from insulation. Vapor Retarder. [ J Required on the warm-in-winter side of all non-vented framed ceilings,walls,and floors. Materials Identification: [ J Materials and equipment must be installed in accordance with the manufacturer's installation instructions. [ I Materials and equipment must be identified so that compliance can be determined. [ J Manufacturer manuals for all installed heating and cooling equipment and service water heating equipment must be provided. [ ] Insulation R-'values,glazing U-factors,and heating equipment efficiency must be clearly marked on the building plans or specifications. Duct laudation: [ J Ducts in unconditioned spaces must be insulated to R-5. Ducts outside the building must be insulated to R-8.0. Duct Construction: [ J All joints,seams,and connections must be securely fastened with welds,gaskets,mastics (adhesives),mastic-plus-embedded-fabric,or tapes. Duct tape is not permitted. Exception:Continuously welded and locking-type longitudinal joints and seams on ducts operating at less than 2 in.w.g.(500 Pa). [ I Ducts shall be supported every 10 feet or in accordance with the manufacturer's instructions. [ J Cooling ducts with exterior insulation must be covered with a vapor retarder. [ I Air filters are required in the return air system. [ ] The HVAC system must provide a means for balancing air and water systems. Temperature Controls: [ 1 Thermostats are required for each separate HVAC system. A manual or automatic means to partially restrict or shut off the heating and/or cooling input to each zone or floor shall be provided Service Water Heating: [ ] Water heaters with vertical pipe risers must have a heat trap on both the inlet and outlet unless the water heater has an integral heat trap or is part of a circulating system. [ I Insulate circulating hot water pipes to the levels in Table 1. Circulating Hot Water Systems: [ J Insulate circulating hot water pipes to the levels in Table 1. Swimming Pools: I I All heated swimming pools must have an on/off heater switch and require a cover unless over 20% of the heating energy is from non-depletable sources. Pool pumps require a time clock. Heating and Cooling Piping Insulation: [ I I HVAC piping conveying fluids above 105°F or chilled fluids below 55 °P must be insulated to the f levels in Table 2.