Laserfiche WebLink
1.05 PROJECT CONDITIONS <br /> A. Conditions Affecting Excavations: The following project conditions apply: <br /> 1. Site Information: Subsurface conditions were investigated during the design of the Project. Reports of these <br /> investigations are available for information only; data in the reports are not intended as representations or <br /> warranties of accuracy of continuity of conditions. The Owner will not be responsible for interpretations or <br /> conclusions drawn from this information. <br /> 1.06 SEQUENCE AND SCHEDULING <br /> A. Coordinate the size and location of concrete pads. Provide templates for layout and location of anchor bolt inserts <br /> cast into pad. <br /> B. Coordinate the installation of pipe sleeves for floor and wall foundation wall penetrations. <br /> C. Coordinate the size and location of structural steel support members with ductwork, HVAC equipment, heating, <br /> cooling and plumbing piping. <br /> PART 2: PRODUCTS <br /> 2.01 MISCELLANEOUS METALS <br /> A. Steel plates,shapes,bars,and bar grating: ASTM A 36. <br /> B. Cold-Formed Steel Tubing: ASTM A 500. <br /> C. Hot-Rolled Steel Tubing: ASTM A 501. <br /> D. Steel Pipe: ASTM A 53,Schedule 40,welded. <br /> E. Nonsluink, Nonmetallic Grout: Premixed, factory-packaged, nonstaining, noncorrosive, nongaseous grout, <br /> recommended for interior and exterior applications. <br /> F. Fasteners: Zinc-coated,type,grade,and class as required. <br /> PART 3: EXECUTION <br /> 3.01 EXAMINATION <br /> A. Examine substrates, areas, and conditions,with Installer present, for compliance with requirements for installation <br /> tolerances and other conditions affecting installation. Do not proceed with installation until unsatisfactory <br /> conditions have been corrected. <br /> 3.02 EXCAVATION <br /> A. General: Refer to Division 2 Section"Earthwork" for excavation methods and the following list of soils handling <br /> techniques: <br /> 1. Shoring and Bracing <br /> 2. Materials Stockpiling <br /> 3. Backfilling and Compaction <br /> 15050-3 No.99132-CP2 <br />