Laserfiche WebLink
' 2.05 GLASS <br /> A. Provide products specified in Section 08800. <br /> B. Conform to requirements of Section 08800. <br /> 2.06 FABRICATION <br /> A. Any dimensions which may vary are indicated on drawings, with maximum and minimum dimensions required to <br /> achieve design requirements and coordination with other work. Field verify all opening dimensions. <br /> ' B. Fabrication: To greatest extent possible,complete fabrication assembly,and finishing at manufacturers plant before <br /> shipment to project site. Disassemble components only as necessary for shipment and installation. <br /> ' 1. Maintain accurate relation of planes and angles,with hairline fit of contacting members. <br /> 2. Select members for fabrication so that adjacent anodized extruded aluminum members do not have color or <br /> ' texture variation greater than half the range indicated in the submitted samples. <br /> 3. Factory-install all hardware except surface-mounted items. <br /> 4. Perform fabrication operations, including cutting, fitting, forming, drilling, and grinding of metal work, in <br /> manner which prevents damage to exposed finish surfaces. <br /> ' a. For hardware,perform these operations prior to application of finishes. <br /> C. Welding: Comply with AWS recommendations to avoid discoloration; grind exposed welds smooth and restore <br /> mechanical finish. <br /> D. Reinforcing: Install reinforcing as required for hardware and as necessary for performance requirements, sag <br /> resistance,and rigidity;separate dissimilar metals as specified under"Installation." <br /> PART 3: EXECUTION <br /> 3.01 PREPARATION <br /> A. Verify and coordinate installation tolerances. <br /> B. Verify that openings are properly prepared,with blocking installed and cavities sealed. <br /> 3.02 INSTALLATION <br /> A. Comply with manufacturer's instructions and recommendations for installation of components. <br /> ' B. Install plastic flashing under all sills and sill flashing. Turn up at ends to form end dams. Set in full bed of mastic, <br /> lap flashing 4"minimum and seal. Secure to wall with keeper strip. <br /> ' C. Set units plumb,level,and true to line,without warp or rack. Provide proper support and anchor securely in place. <br /> D. Separate aluminum exposed to weather from dissimilar metals; coat dissimilar metals that are in drainage cavities <br /> using one of the materials specified. Aluminum,stainless steel,zinc,cadmium,and small areas of white bronze are <br /> not considered dissimilar from each other. <br /> E. Coat all metals that come into contact with masonry, concrete, and treated wood, using one of the materials <br /> ' specified. <br /> 08521-5 No.99132-CP2 <br />