Laserfiche WebLink
2.05 FACTORY FINISHING <br /> A. General: comply with applicable requirements of AWI Quality Standards, Section 1500,for types of finish systems <br /> indicated. <br /> B. Transparent Finish: <br /> ' 1. Type: Factory finish to be water-based stain and ultraviolet(UV) cured polyurethane sealer to comply with <br /> EPA Title 5 guidelines for Volatile Organic Compound (VOC) emissions limitations. Finish must meet or <br /> exceed performance standards of AWI TR-6 catalyzed polyurethane. <br /> 2. Stain color: See Material Finish/Color Schedule,Sections 1-4 of Details of Construction. <br /> 3. Grain effect: Closed. <br /> 4. Sheen: Satin(low luster). <br /> ' 5. Grade: Premium. <br /> PART 3: EXECUTION <br /> 3.01 INSPECTION <br /> ' A. Require installer to examine door frames after their installation, and doors prior to their hanging, for the following <br /> purposes: <br /> 1. To verify that frames comply with indicated requirements for type, size, location, and swing characteristics. <br /> and have been installed with plumb jambs and level heads. <br /> 2. To verify that doors are free of defects. <br /> B. Obtain installer's written report listing conditions detrimental to compliance with requirements of this section. <br /> C. Do not proceed with installation until unsatisfactory conditions have been corrected. <br /> 3.02 INSTALLATION <br /> A. Condition doors to average prevailing humidity in installation area prior to hanging. <br /> B. Hardware Installation: Section 08700. <br /> C. Install wood doors in accordance with manufacturer's instructions and referenced standards. <br /> 1. Installation of the wood doors,and labeled wood doors shall comply with NWWDA I.S.1-A, Installation and <br /> NFPA 80. <br /> 2. Dimensional tolerances for hardware cutouts, undercuts, meeting edges, heights and width shall comply with <br /> NWWDA I.S.1-A,G-14. <br /> D. Prefit Doors: Fit to frames and machine for hardware to whatever extent not previously worked at factory as <br /> required for fit and uniform clearance at each edge. <br /> E. Shop-Finished Doors: Restore finish on edges of shop-finished doors before installation, if fitting or machining is <br /> required at the project site. Touch up any scratched doors to satisfaction of Architect prior to substantial <br /> completion or replace doors. <br /> 08200-5 No.99132-CP2 <br />