|
i
<br /> SECTION 16140
<br /> WIRING DEVICES
<br /> �
<br /> 1.00 GENERAL
<br /> ' A. Switches for lighting loads shall be 15 amp, 120 volt, quiet toggle type, quickwire
<br /> push-in and side wired. Switches shall be ivory in color unless noted otherwise.
<br /> � B. Duplex receptacles shall be 15 amp or 20 amp, 125 volt, 3 wire, grounding type
<br /> quickwire push-in and side or back and side wired. Install 20 amp rated duplex
<br /> receptacles in all common areas. All receptacles shall be installed with the ground slot
<br /> ' down. Provide GFI receptacles where shown or required by the NEC and install with
<br /> ground slot down. Receptacles shall be ivory in color unless noted otherwise.
<br /> , C. Special receptacles shall be the same color and manufacturer as other devices.
<br /> D. Device plates shall be provided for all receptacles and special receptacles. Device plates
<br /> in finished and unfinished areas shall be plastic, ivory in color, unless noted otherwise.
<br /> ' Multiple device plates shall be constructed of a single plate. No sectional plates will be
<br /> accepted.
<br /> , E. Switches shall be equal to the following:
<br /> 1. 15 amp, 120 volt, single pole Leviton#1451-I
<br /> , 2. 20 amp, 120 volt, single pole Leviton#54521-2I
<br /> 3. 15 amp, 120 volt, 3-way Leviton#1453-I
<br /> 4. 20 amp, 120 volt, 3-way Leviton#54523-2I
<br /> 5. 15 amp, 120 volt,4-way Leviton#2654I
<br /> ' 6. 20 amp, 120 volt, 4way Leviton#54529-2I
<br /> 7. 20 amp, 120 volt, 2-pole Leviton#54522-2I
<br /> , F. Dimmers shall be as follows:
<br /> 1. 600 watt, 120 volt Lutron#NT-600
<br /> 2. 100 watt, 120 volt Lutron#NT-1000
<br /> , 3. 1,500 watt, 120 volt Lutron#NT-1500
<br /> G. Receptacles shall be equal to the following:
<br /> ' 1. 15 amp, 125 volt Leviton#5320-I
<br /> 2. 15 amp, 125 volt, GFT Hubbell #GF5251-I
<br /> ' 3. 20 amp, 125 volt Leviton#BR20-I
<br /> 4. 20 amp, 125 volt, GFT Hubbell #GF5352-I
<br /> H. Special receptacles shall be equal to the following:
<br /> ' 1. 20 amp, 250 volt Leviton#5821-I
<br /> 2. 30 amp, 125/250 volt, 3-pole, 4-wire, grounding Leviton#278
<br /> , 3. 50 amp, 125/250 volt, 3-pole, 4-wire, grounding Leviton#279
<br /> I. Switches, receptacles and outlets shall be mounted at the following heights, measured
<br /> , from device center to floor, unless noted otherwise.
<br /> , RMAS CBA701 8/1/97
<br /> 061997 16140 - 1
<br /> '
<br />
|