Laserfiche WebLink
Y <br /> 1.07 DELIVERY, STORAGE, AND PROTECTION <br /> A. Section 01600 — Material and Equipment: Transport, handle, store, and protect <br /> products. <br /> B. Accept frames on site in manufacturer's packaging. Inspect for damage. <br /> 1.08 PROJECT CONDITIONS <br /> A. Coordinate the work with frame opening construction, door, and hardware <br /> installation. <br /> B. Sequence installation to ensure wire connections are achieved in an orderly and <br /> expeditious manner. <br /> J <br /> PART 2 PRODUCTS <br /> 2.01 FRAME MANUFACTURERS ��� <br /> A. See Door Manufacturers, Section 08111. <br /> 2.02 FRAMES <br /> `� <br /> A. Frames: To suit SDI-100 Grade and Model of door specified in Section 08111. <br /> 2.03 ACCESSORIES � <br /> A. Removable Stops: Rolled steel channel shape, butted corners; prepared for <br /> countersink style screws. ;µ� <br /> B. Bituminous Coating: Fibered asphalt emulsion. <br /> C. Primer: Zinc chromate type. <br /> D. Silencers: Resilient rubber set in steel channel fitted into drilled hole. � <br /> E. Weatherstripping: Resilient rubber set in steel frame. <br /> 2.04 FABRICATION '� <br /> A. Fabricate frames as welded unit. <br /> B. Fabricate frames with hardware reinforcement plates welded in place. <br /> C. Reinforce frames wider than 48 inches with roll formed steel channels fitted tightly <br /> into frame head, flush with top. <br /> D. Terminate door stops 6 inches above finished floor. Cut stop at 45 degree angle and <br /> close. <br /> E. Prepare frames for silencers. Provide three single silencers for singly doors on <br /> strike side. Provide two single silencers on frame head at double doors without <br /> mullions. <br /> F. Attach fire rated label to each fire rated door unit. <br /> G. Fabricate frames to suit masonry wall coursing with 4-inch head member. <br /> � <br /> Division 8—Section 08112 � <br /> Page 2 of 3 <br /> �� <br />