Laserfiche WebLink
nonencroachments when they conform with the following standards: <br /> a. Each monument, with a maximum of two per approved driveway access, <br /> shall be limited to a single pillar with a footprint measuring no larger than <br /> 25 square feet and no length to exceed five feet; <br /> b. The monument must be setback a minimum of five feet from all property <br /> boundaries and never fewer than ten feet from the edge of the paved, <br /> traveled roadway; <br /> c. Plans and/or elevation views of the proposed monuments are required to <br /> be submitted for approval by the planning director; <br /> d. All signage proposed for the monuments must comply with section 78- <br /> 1467; <br /> e. The monuments are limited to eight feet in height including any <br /> appurtenances. Any monument exceeding the maximum height must <br /> meet principal structure setback requirements; <br /> f. When more than one monument is proposed, and serving two or fewer <br /> residences, a minimum horizontal width of 16 feet is required between <br /> them; <br /> g. When more than one monument is proposed, and serving three or more <br /> residences, a minimum horizontal width of 22 feet is required between <br /> them; <br /> h. Lighting is allowed, in conformance with section 78-1573 and at the <br /> discretion of the planning director. <br /> i. When a gate is proposed, the following requirements must be met: <br /> 1. The gate must open into the property not outward towards the <br /> right-of-way, and <br /> 2. Gates serving two or fewer residences shall have a minimum <br /> horizontal width of 14 feet in the full open position, and <br /> 3. Gates serving three or more residences shall have a minimum <br /> horizontal width of 20 feet in the full open position, and <br /> 4. For all properties, gate height may not exceed the height of the <br /> monument, measured from grade, unless principal structure <br /> setbacks are met (if monuments are not proposed then gate <br /> height shall be regulated in accordance with the fence height <br /> regulations of section 78-1405(7), and <br /> 5. Gates must maintain an opacity level of no greater than 25 <br /> percent, and <br /> 6. For locked and/or secured gates a knox box, meeting the <br /> standards set forth by the police and fire department, must be <br /> provided for emergency access, and <br /> 7. On major thoroughfares the monuments and gates must be <br /> located 40 feet from the paved, traveled road to allow for vehicle <br /> stacking. A major thoroughfare for the purposes of this section <br /> means any county road or state highway. <br /> j. A building permit is required for installation. A survey must be submitted <br /> depicting where the monuments will be placed, and the property corner <br /> pins must be located for inspection purposes. <br />