Laserfiche WebLink
ESR-1715 I Most�dely Accepted and Trusted Page 3 of 5 <br /> TABLE 7—MAJESTIC SLATE ROOF TILES AND SENECA SHAKE CEDAR SHAKE ROOF TILES <br /> ALLOWABLE WIND UPLIFT' <br /> SYSTEM ALLOWABLE DECK UNDERLAYMENT FASTENER DETAILS <br /> NO. WIND UPLIFT <br /> (ps� <br /> Each roof tile is attached to the plywood with two, 1'/2-inch- <br /> Min15/,Z-inch-thick One layer of Type II long,ring shank nails per tile.The nails must have a minimum <br /> 1 52.5 APA rated plywood asphalt saturated felt, shank diameter of 0.143 inch.Nails must be placed at <br /> Type C-D mechanically attached. locations that are specified on each tile.Maximum exposure of <br /> the Majestic Slate Roof Tiles is 7 inches,and for the Seneca <br /> Cedar Shake Roof Tiles shingles,8 inches. <br /> Each roof tile is attached to the plywood with two, 1'/Z-inch- <br /> One layer of Type II long,ring shank nails per tile.The nails must have a minimum <br /> 2 60 Min'/,6-inch OSB asphalt saturated felt, shank diameter of 0.143 inch. Nails must be placed at <br /> mechanically attached, locations that are specified on each tile.Maximum exposure of <br /> the Majestic Slate Roof Tiles is 7 inches,and for the Seneca <br /> Cedar Shake Roof Tiles shingles,8 inches. <br /> Each roof tile is attached to the plywood with three, 1'/z-inch- <br /> long,ring shank nails per tile.The nails must have a minimum <br /> One layer of Type II shank diameter of 0.143 inch.Two nails must be placed at <br /> 3 90 Min'/,6-inch OSB asphalt saturated felt, locations that are specified on each tile.The third nail is to be <br /> mechanically attached. Placed offset from the center approximately 1 inch to ensure <br /> coverage by the overlapping tile.Maximum exposure of the <br /> Majestic Slate Roof Tiles shingles is 7 inches,and for the <br /> Seneca Cedar Shake Roof Tiles shingles,8 inches. <br /> For SI:1 inch=25.4 mm, 1 psf=47.88 Pa. <br />