2005-P08409 - new structure - Laserfiche WebLink

Home Browse Search

:;��"�'.�� I�a��x ' - � �� ,. NER-604 LEGACY REPORT Re-Issued November 1, 2003 ICC Evaluation Service, �11C. Business/Regional Office�5360 Workman Mill Road,Whitier,Califomia 90601 �(562)69�-0543 WWW.ICC-@S.O�g Regional Office■900 Montdair Road,Suite A,Birmingham,Alabama 35213 ■(205)599-9800 Regional Office�4051 West Fbssmoor Road,Country Club Hills,Illinois 60478�(708)79&2305 Legacy report on the 2000 International Building Code°, the 2000 Internationa/ Residentia/ Code°, the 2002 Accumulative Supplement to the International Codes`",the BOCA�National Building Code/1999,the 1999 Standard Building Code°,the 1999 Uniform Building Code`",and the 1998 International One and Two Family Dwelling Code�, SBCCI Standard for Hurricane Resistant Residential Construction SSTD 10-99 DIVISION 03-CONCRETE mm),and two standard widths of 9.25 and 11 inches(234.95 Section 03130-Permanent Forms and 279.4 mm). The 9.25 inch(234.95 mm)form has 6 inch nominal (152.4 mm)cores and the 11 inch(279.4 mm)form REWARD WALL SYSTEMS, INC. has 8 inch nominal(203.2 mm)cores. The cores of the forms 4115 SOUTH 87TH STREET are filled with concrete and reinforcing steel to construct a OMAHA, NEBRASKA 68127 solid monolithic concrete wall. The concrete wall consists of 1-800-468-6344 vertical "columns" spaced 12 inches (304.8 mm) on center www.rewardwalls.com and horizontal "beams" spaced 16 inches (406.4 mm) on center. The top and bottom edge of the forms are provided 1.0 SUBJECT with lap joints for interlocking of units. Reward Wall Systems0 3.1.2 iFORMT"' Flat ICF forms are hollow core forms of 1.1 eFORMT^^ expanded polystyrene face shells connected with plastic 1.2 iFORMT^^ bridge connectors that are also used to attach interior and exteriorfinishes. The forms are available in a standard length 2.0 PROPERTIES FOR WHICH EVALUATION IS of 48 inches (1219.2 mm), height of 16 inches (406.4 mm) SOUGHT and three standard widths of 9 inches(228.6 mm), 11 inches (279.4 mm) and 13 inches (330.2 mm). The 9 inch (228.6 mm) from has a 4 inch (101.6 mm) nominal concrete core, 2.1 Formwork for structural concrete the 11 inch(279.4 mm)form has a 6 inch(152.4 mm)nominal 2.2 Surface burning characteristics concrete core and the 13 inch(330.2 mm)form has an 8 inch 2.3 Crawl space fire evaluation (203.2 mm) nominal concrete core. Vertical and Horizontal 2.4 Fire resistive rated wall assemblies Reinforcing Steel,when specified, is placed inside the forms 2.5 Installation in buildings of noncombustible and supported by the webs.The forms are filled with concrete construction,see Section 4.6 to produce a solid monolithic flat concrete wall. The top and bottom edge of the forms have a loose fit"tooth"design for 3.0 DESCRIPTION interlocking of units. 3.1 General 3.2 Materials Reward Wall Systems0 forms are used as permanent 3.2.1 Polystyrene: Nominal density of 1.5 pcf (24.03 formwork for structural concrete load bearing and non-load kg/m3) and a maximum 2 pcf (32.04 kg/m3) density with bearing residential and commercial, below grade and above flamespread index (FSI) of 25 or less and a smoke grade walls. The forms are permitted to be used in buildings development index(SDI) of 450 or less when tested under of noncombustible construction when installed in accordance ASTM E 84. with Section 4.6 of this report. The forms are used in construction of plain and reinforced concrete beams, lintels, 3.2.2 Bridge Inserts: Plastic connectors for attaching exterior and interiorwalls,and foundation and retaining walls. interior and exterior finishes. The eFORM plastic connectors The forms remain in place after setting of concrete and shall are located 12 inches (304.8 mm) on center and are be protected by an approved interior and exterior finish embedded or recessed 1/4 inch (6.35 mm) into the foam material. The Reward Wall System0 eFORMT"' forms are block. The iFORM plastic connectors are located 6 inches classified as a waffle-grid ICF(insulating concrete form)wall (152.4 mm)on center and are embedded or recessed Yz inch system. The Reward Wall System0 iFORMT"' forms are (12.7 mm)into the foam block. Both blocks have continuous classified as a flat ICF(insulating concrete form)wall system. vertical ties. 3.1.1 eFORMT^' Waffle-Grid ICF forms are hollow core 3.2.3 Concrete: Normal-weight concrete,complying with forms of expanded polystyrene face shells connected with the applicable Code, with a maximum 3/4 inch (19 mm) plastic bridge connectors that are also used to attach interior aggregate and a minimum compressive strength of 2500 psi and exterior finishes. The forms are available in a standard (17250 kPa) at 28 days, except as noted in Table 1 of this length of 48 inches(1219.2 mm), height of 16 inches(406.4 /CGES legacy reporls are ria!to be construed as representing aesthelics or any orher anributes nor speci�cally addressed,nor are they to be construeJ as un endorsemen!�f the e�ubject af the reyart or u recommendatian for i�e•ue•e.There is na warrunry by!CC Eva6�ution Service,lne.,e.rpree�e•or imylied,us to � uny finding ar other mutter in this revort,or us to uny product covered by the repart. � „qr �"'w�+e u.r..�^ Page 1 of 6 CopyrightOO 2003