Laserfiche WebLink
BARBOUR/LADOUCEUR ARCHITECTS, PA. <br /> wiTH DWELL PARTNERS, LLC <br /> MILLER- ARTEMIUK HOME <br /> NEW CONSTRUCTION <br /> ORONo, MN <br /> 22) Painting System: <br /> a) Exterior wood siding, trim, fascia, doors and windows <br /> i) 2 coats Sikkens: Cetol 1 &Cetol DEK(use product applicable to surface conditions.) <br /> b) Drywall (walls and ceilings; there will be no textured ceilings.) <br /> i) 1 coat latex primer <br /> ii) 2 coats interior latex enamel, satin finish <br /> c) Hardwood flooring <br /> i) 3 coats clear polyurethane finish <br /> d) Wood (Transparent finish: wood doors, millwork, trim, etc.) <br /> i) 1 coat spar varnish -gloss <br /> ii) 1 coat spar varnish -satin <br /> e) Wood (painted finish: wood doors, millwork, trim, etc.) <br /> i) 1 coat alkyd primer <br /> ii) 2 coats alkyd enamel -satin <br /> Carpetinq <br /> 1) All carpeting will be selected by owner. <br /> 2} Work included: Provide carpeting and carpet accessories where shown on Drawings, as specified <br /> herein, and as needed for a proper installation. <br /> 3) Provide and install carpet as specified on Room Finish Schedules. <br /> 4) Provide other materials not specifically described but required for a complete and proper installation, <br /> as selected by the Contractor subject to the approval of the Owner. <br /> 5) Examine the areas and conditions under which work of this Section will be performed. Correct <br /> conditions detrimental to timely and proper completion of the work. Do not proceed until <br /> unsatisfactory conditions are corrected. <br /> 6) Immediately prior to installation of the work of this Section, thoroughly clean substrate and remove <br /> oil, grease, paint, varnish, hardeners, and other items that would adversely affect the bond of the <br /> adhesive. <br /> 7) Make substrata level and free from irregularities. Assure one constant floor height after carpet is <br /> installed, filling low spots and grinding high spots as required. <br /> 8) General installation: Stretch carpet in manner recommended by manufacturer. Scribe the carpet <br /> accurately to vertical surfaces. Align the lines of carpet, as woven, using no fill strips less than 6 <br /> inches wide, laying all carpet in the same direction unless specifically directed otherwise by <br /> Architect.. <br /> 9) Seams: Locate seams to the maximum extent practicable out of the way of traffic. Fabricate seams <br /> by the compression method using a butt joint and properly bead and seal. Do not stretch seams. <br /> 10) In addition to the cleaning requirements stated elsewhere, thoroughly clean carpet and adjacent <br /> surfaces prior to final acceptance of the carpeted areas by the Owner. <br /> 129 N. SECOND STREET SUITE 103 MINNEAPOLIS MN 55401 <br /> 612 339 5093 (PH) 612 339 0499 (FAx) WWW.BAR-LAD-ARCH.COM <br /> Specifications-9 <br />