Laserfiche WebLink
c � . <br /> 16100 Electrical Wiring <br /> A. Provide materials for, and install electrical systems as shown on the Drawings, specified herein, as may be <br /> required for a complete installation: <br /> 1. Materials, not specified herein, and installed as work of this Section are by allowance — refer to Section <br /> 16500 LIGHT FIXTURES. <br /> B. Portion of the work of this Section is under Alternate Bid — Refer to Section 00420 SUPPLEMENTS TO BID, <br /> List of Altemate Bids: <br /> 1. Base Bid: Wiring for gas-fired unit heater in Garage and in-floor hydronic heating throughout the Lower <br /> Level and within the Master Bath <br /> 2. Alternate Bid: In-floor hydronic heating system at the Garage, in lieu of gas-fired unit heater <br /> 3. Alternate Bid: Under-floor (transite duct) forced air heating system at the Lower Level, in lieu of in-floor <br /> hydronic heating system <br /> 4. Alternate Bid: In-floor electrical heating system at the Master Bath, in lieu of in-floor hydronic heating <br /> system <br /> 5. Alternate Bid: Wiring for Sauna in Lower Level. <br /> C. Electrical Materials: <br /> 1. Devices (switches and receptacles): �Decora"; white. <br /> 2. AirNapor Barrier Rough-In boxes: "LESSCO" (Shelter Supply). <br /> 3. Food Prep. and Kitchenette Plug Mold: Hubbell; plastic. <br /> D. Site Utilities: Make arrangements with the Electrical Utility for provision of underground, 400 ampere (verify), <br /> electrical service to the site and building. Verify exact location of ineter and main and subpanels. <br /> E. Coordinate electrical requirements at all equipment and appliances. <br /> F. Layout of circuits and quantities and locations of receptacles and switching shall be as determined by the <br /> Electrical Subcontractor for purposes of bidding. The Electrical Subcontractor shall conduct walk-through with <br /> the Owner and the Architect to review final lighting, switching and outlet locations. <br /> G. Provide and install plastic air/vapor barrier boxes at all electrical outlets and switches at perimeter insulated <br /> walls. <br /> H. In Food Prep. and Kitchenette areas, install plastic, continuous plug mold at underside of upper cabinets, so <br /> as to avoid wall receptactes. <br /> , <br /> 633 SPECIFICATIONS <br /> Page 76 <br />