Correspondence re bldg permit (permit not in file)

Home Browse Search

Mr. Lyle Oman -2- March 24, 1995 City of Orono Mechanical - Gara�e 1) Install a new natural gas line from the existing meter at the south end of the existing greenhouse to the existing garage. Note: Kraus-Anderson to remove and replace blacktop driveway as needed. 2) Furnish and install (2) 75,000 BTU natural gas fired unit heaters, one in each corner of the garage near the back wall. The units will be complete with Class B stacks and line voltage thermostats. Mechanical - Greenhouse 1) Install a natural gas line to the (2) Modine propeller unit heaters, which are furnished and installed by the Rou�h Brothers Company. 2) Furnish and install (2) new floor drains and connect the new waste line to existing floor drain, this waste line will extend back into the existing mechanical room where waste connection will be made. This new line will have a vent line extended through the greenhouse roof, an opening in roof should be provided by Rough Brothers Company. Note: There would be approximately 30 sq. ft. of concrete for Kraus-Anderson to cut and patch. 3) Furnish and install (4) frost proof outdoor sillcocks. Two on the west side and two on the east side of the new greenhouse. No pipe covering on any water lines. 4) Install a 1/2" water supply to the Rough Brothers Company furnished and installed 100 gallon sump tank. This line will be protected with a R.P.Z. valve. 5) Furnish and install (6) cold water faucets (Chicago number 998 with vacuum breakers). Three on the west wall and three on the east wall. 6) Furnish and install (1) 50,000 BTU natural gas fired unit heater, this would be necessary to protect the P-trap for the floor drain in the upper level floor or this would ha�e to have a heating tape on it. There would be a 4" Class B chimney run up through the new greenhouse, Rough Brothers would ha�e to provide openin� in the roof of tne greenhouse for the stack to pass through. We will furnish a line voltage thermostat, but Kraus-Anderson's electrical contractor will have to do power and control wirin�.