Laserfiche WebLink
<br /> <br /> <br />12 _________ <br /> Initial <br /> <br />Body Threshold Panel <br />Rear body side modules shall be jointed with a middle bottom bolted aluminum sheet <br />reinforced on four sides. <br /> <br />Handrails <br />Two (2) 12’’ access handrails shall be provided at the rear of the body, one (1) on each <br />side. Handrails shall be constructed of or covered with a slip-resistant, non-corrosive <br />material. Handrails shall be between 1in. and 1-5/8 in. in diameter and have a minimum <br />clearance between the handrails and any surface of at least 2 in. <br /> <br />Six (6) Rear Folding Steps <br />The rear of the body shall have Six (6) non-skid folding steps, three (3) on each side. <br />The rear steps shall be made so it can be folded up for use in rough terrain. All steps <br />shall sustain a minimum static load of 500 lbs. (227 kg) without deformation (NFPA 1906 <br />& 1901 compliant). <br /> <br />Tow Eyes <br />Two (2) tow eyes shall be attached directly to the frame structure to provide a means to <br />allow recovery from the front and rear. Hardware shall have a clear and unobstructed <br />access. <br /> <br />Paint <br />The paint or coating, including any primer, shall be applied in accordance with the paint <br />or coating manufacturer’s recommendation. <br /> <br />Body Modules shall be thoroughly washed with grease cutting solvents prior to any <br />sanding. After the body has been sanded and the minor imperfections corrected, the body <br />shall be washed again with a solution to remove any contaminants on the surface. The <br />first coating to be applied is a universal plastics adhesion promoter followed with three <br />coats of primer. The primer coat is to be hand sanded with 320 grit sandpaper to insure <br />maximum gloss of the paint. <br /> <br />The polybody paint shall be one (1) color and it shall be painted Black. <br /> <br />The exact color shall be determined during body construction. <br /> <br />All exposed ferrous metal surfaces that are not plated or stainless steel shall be cleaned <br />and prepared and shall be painted or coated. The interior of the body compartments shall <br />be left in their natural color of white. <br /> <br />Wheel Chocks <br />Medium Kochek Wheel Chocks with storage brackets shall be provided and mounted <br />underneath the flatbed behind the chassis cab. <br /> <br />Rear Mud Flaps <br />Rear rubber mud flaps are provided. A bracket attached to the side of the muffler pipe end <br />is installed to prevent any damaged that can occur to the mud flap. <br /> <br />Rear Chevron <br />6” reflective red & Black chevron stripes shall be applied at rear of apparatus covering the <br />entire area (rear door included). <br /> <br />179