Laserfiche WebLink
<br /> <br /> <br />11 _________ <br /> Initial <br /> <br />Right (Passenger) Side Storage Hose Tray <br />One (1) storage hose tray shall be supplied and installed on top of right (passenger) side <br />compartment. <br /> <br />Dimensions of the storage tray shall be 110” long X 22-3/4’’ wide X 8” high. <br /> <br />Black canvas with snaps shall be installed on top of the storage tray along with rear <br />protective net. <br /> <br />The area shall be designed to prevent the accumulation of water and allow for ventilation <br />to aid in drying hose in the storage area. <br /> <br />The external face of the hose tray shall be painted black. <br /> <br />Three (3) SCBA Wheel Well Bottle Storages <br />Three (3) SCBA bottle storages shall be installed above the rear wheel well. The shall <br />have One (1) on the left (driver) side of the polybody and Two (2) one the right (passenger) <br />side of the polybody, one (1) storage forward and one (1) backward of the rear wheels. <br />Each bottle storage shall have a polished aluminum hinged door with latch assembly. <br /> <br />The external face of the door shall be painted black. <br /> <br />Black Rubber Fenderettes <br />The rear wheel wells shall be radius cut with black rubber fenderettes installed at well <br />opening. <br /> <br />Black Rubber Rub Rail <br />A Poly black rubber rub rail shall be bolted on both sides of the body below the <br />compartment to protect the body from minor scrapes. <br /> <br />Fuel Fill Bezel <br />A fuel fill bezel shall be supplied and installed behind the rear wheels on the driver side of <br />the poly body. <br /> <br />Subframe <br />A stainless-steel subframe weldment shall be fabricated from tubing and formed sheet <br />metal to provide a mounting platform for the body side modules and the floor. There shall <br />be outriggers extending out and down from the sub frame to provide support to the side <br />pack floors. There shall be a minimum of four (4) outriggers supporting each side module. <br />There shall be common attachment points along the length of the sub frame for mounting <br />it to the truck chassis. The finish on the subframe shall be painted black. <br /> <br />Body Header Panel <br />A formed .125” high smooth aluminum panel shall be provided at the front of the body and <br />shall extend the full width and height of the body to provide full frontal protection to the <br />body side modules. The header panel shall be fastened to both body side modules. Steel <br />cross members shall be installed at front. <br /> <br />The header shall be covered by Black Bed Liner. <br /> <br />178