Laserfiche WebLink
<br /> <br />10 <br />three coats of primer. The primer coat is to be hand sanded with 320 grit sandpaper to <br />insure maximum gloss of the paint. <br /> <br />The polybody paint shall be one (1) color red to match the chassis cab color. <br /> <br />All exposed ferrous metal surfaces that are not plated or stainless steel shall be cleaned <br />and prepared and shall be painted or coated. The interior of the body compartments <br />shall be left in their natural color of white. <br /> <br />Wheel Chocks <br />Medium Kochek Wheel Chocks with storage brackets shall be provided and mounted <br />underneath the flatbed behind the chassis cab. <br /> <br />Rear Mud Flaps <br />Rear rubber mud flaps are provided. A bracket attached to the side of the muffler pipe <br />end is installed to prevent any damaged that can occur to the mud flap. <br /> <br />Rear Chevron <br />6” reflective red & yellow chevron stripes shall be applied at rear of apparatus covering <br />the entire area. <br /> <br />Electrical Components <br />A 12-volt electrical system is supply. <br /> <br />The wiring is secured in place, readily accessible and protected against heat, water and <br />physical damage. <br /> <br />Electrical harness lines shall be mechanically attached to the frame or body structure of <br />the apparatus. <br /> <br />All wiring will be run in heat and moisture resistant plastic convoluted split loom. <br /> <br />Electrical harness lines shall be furnished with protective looms, grommets, or oth er <br />devices at each point where they pass through body panels or structural members or <br />wherever they lie against a sharp metal edge. A through-the-frame connector shall be <br />permitted to be used in place of metal protective looms or grommets. <br /> <br />Switches, relays, terminals, and connectors shall have a direct current (dc) rating of 125 <br />percent of maximum current for which the circuit is protected. <br /> <br />Conductor insulation will conform to S.A.E. requirements. All circuit are protected by <br />automatic reset circuit breakers. <br /> <br />All wiring furnished will conform to the national Electric Code. <br /> <br />All circuits will be wired in conformance with S.A.E. J1292, Automobile wiring standard. <br /> <br />All wiring will be function worded schematically. <br /> <br />An electric diagram will be remit upon delivery. <br />