Laserfiche WebLink
Report No. : r109SD-086 <br /> � Page : 3 of 5 <br /> CAULKING: The follo�ving were sealed: <br /> 1) The sill to jamb joints were sealed full profile. <br /> 2) The false jamb was sealed to the sill interior leg at to the head center leg. <br /> 3) '�ll scre�ys used to anchor the frame�vere sealed. <br /> 4) Frame perimeter was sealed to the�vood rough opening from the exterior. <br /> ANCHORING: The Sliding Glass Door frame was set in a 2" x 8"rough opening and fastened as follows: <br /> The frame head was fastened to the rough opening with the screws used to secure the T-clips at <br /> the fixed interlock and false jamb. <br /> The sill was fastened with eight#10 x 2.5"PFH screws. <br /> The jambs were each fastened with six#10 x 2.5"PFH screws. <br /> 5.0 TEST PROCEDURES A1�iD RESULTS <br /> 5.1 r1ll testing procedures were performed in accordance with the performance requirements of the test <br /> specifications referenced in paragraph 2.0 of this report. <br /> 5.2 TEST RESULTS <br /> PARAGRAPH TEST DESCRIPTION MEASURED ALLOWED <br /> 5.3.1.1 Operating Force (ASTM E 2068) <br /> Breakaway 22 N (4.9 lbf.) 135 N (301b£) <br /> Motion 18 N (4.0 lb£) 90 N (20 lb£) <br /> 5.3.1.1.3 Latching Devices <br /> Open and Close Latch Device 9 N (2.O lb£) 100 N (22.5 lb£) <br /> 5.3.2.1 Air Infiltration (ASTM E 283) <br /> 75 Pa 1.5 L/s•m2 1.5 L/s•mz <br /> (1.6 PSF� (0.3 CFM/Ft2) (03 CFM/Ft2) <br /> The tested sPecimen mects the performance levcls specified in AA�L�/WDM.�/CSA 101/I.ti.2/A440 for air <br /> lcakage resistancc. <br /> 5.3.3.2 �Y/ater Penetration (ASTM E 547) <br /> 220 Pa (4.50 PSF� No Leakage No Leakage ' <br /> With/without screen <br /> 5.3.4.2 Uniform Load Deflection (ASTM E 330) <br /> For Interlock <br /> 1440 Pa(30.0 PSF� POS 44.50 mm (1.75") Report Only <br /> 1440 Pa(30.0 PSF� NEG 42.00 mm (1.65") Report Only <br /> 5.3.4.3 Uniform Load Structural (ASTM E 330) <br /> 2160 Pa (45.0 PS� POS 1.50 mm (0.06") 725 mm (0.29" Set) <br /> 2160 Pa (45.0 PSF� NEG 1.50 mm (0.06") 7.25 mm (0.29" Set) <br /> 5.3.6.3 Deglazing(ASTM E 987) <br /> 320 N Stiles (701bf.) 10% Less than 90% <br /> 230 N Rails (501bf.) 6% Less than 90% <br />