Laserfiche WebLink
t-.RWnL. IVuva IIIUUbU IWb <br /> Job No.: TJ1768-4 <br /> Date: June 26, 2014 <br /> LADWIM8 Page 2 of 3 <br /> Test Procedure and Results <br /> ASTM E 1494-12(Standard Practice for Encapsulation Testing of Friable Asbestos-Containing <br /> Surfacing Materials) <br /> Qualifications <br /> The test methods in this practice require disturbance of asbestos-containing materials. <br /> Activities that disturb asbestos containing materials are subject to regulations of the <br /> Occupational Safety and Health Administration (OSHA), the Environmental Protection <br /> Agency (EPA) and other jurisdictions including certain state agencies. <br /> The test method described in Annex Al to determine the adhesive and cohesive properties <br /> of encapsulated surfacing material can result in a release of asbestos-containing debris. <br /> Persons conducting this test must have the appropriate credentials and training to clean up <br /> the debris. <br /> i <br /> i <br /> Annex 1 (Test Method to Determine the Cohesion/Adhesion Properties of Friable Spray <br /> or Trowel Applied Asbestos-Containing Surfacing Materials) <br /> Test Preparation <br /> The Duct Armour product was troweled onto (4) 12" by 12" Hardie Panel Cement Backer <br /> Board. The product was allowed to cure in a 70°F/50% relative humidity environment for <br /> 24 hours. Gorilla Epoxy was prepared and placed on the surface of the Duct Armor coating <br /> and a 3° by 4° steel plate was placed on top of the epoxy with approximately 5 lbs of force. <br /> The assembly was allowed to cure for an additional 24 hours. <br /> Test Procedure <br /> The 12" by 12" assemblies were placed on the bottom of a universal tensile testing fixture. <br /> The panels were secured by placing W thick steel plates that over lapped the edges of the <br /> backer board panel by 3/4". The 3" by 4" steel plate adhered to the Duct Armor coating was <br /> then connected to the top of the universal test fixture. The rate of tension used for this <br /> testing was 1 in/ min. <br /> THIS REPORT IS THE CONFIDENTIAL PROPERTY OF THE CLIENT ADDRESSED.THE REPORT MAY ONLY BE REPRODUCED IN FULL.PUBLICATION OF EXTRACTS FROM THIS REPORT IS <br /> NOT PERMITTED WITHOUT WRITTEN APPROVAL FROM QAI.ANY LIABILITY ATTACHED THERETO IS LIMITED TO THE FEE CHARGED FOR THE INDIVIDUAL PROJECT FILE REFERENCED. <br /> THE RESULTS OF THIS REPORT PERTAIN ONLY TO THE SPECIFIC SAMPLE(S)EVALUATED. <br /> WWW.QAI.ORG <br /> info(Pgai.org <br />