Laserfiche WebLink
v< <br /> 1 <br /> Step #2: Seal and anchor the flashing <br /> • At jamb conditions attach a P1153 end dam to the end of the sill flashing with two 5196 screws and <br /> seal the sill flashing to the end dam as shown in the illustration on page 36. <br /> • Butt the flashing up against the back of the doorjamb(if present)and seal the flashing to the back of <br /> the entrance frame as shown in the illustration below. <br /> • Place shims (not by Tubelite)under the flashing as needed to support the flashing and level it. <br /> • Drill holes for anchor bolts through the flashing and into the masonry, and secure the flashing with <br /> bolts, as specified in the approved shop drawings. <br /> • Cap seal all anchor bolts with silicone sealant. <br /> E-14021 <br /> doorjamb <br /> Sealant E-14159 Or T-14259 sill <br /> Cap seal flashing <br /> anchors <br /> Sealant <br /> _w""�wri�wiw <br /> V <br /> Sealant �u1, <br /> Shim(not by <br /> Tubelite) <br /> Sealing sill flashing to a door frame <br /> 14000 Series—Revision December 01, 2009 Page 35 of 44 <br />