Laserfiche WebLink
Ar _;?i_'I � " � Z(: <br /> FRAME INSTALLATION <br /> If there is an entrance, you should install it first, taking care to locate the entrance frame accurately <br /> within the opening. <br /> Step #1 (if needed): Splice the flashing where required per final distribution dwgs. <br /> • Place the flashing in the opening. The gap between any two pieces of flashing should be 3/8"to 1/2" <br /> wide. <br /> • Attach the splice (P-1144)to the back of one piece of flashing with double-faced tape. <br /> • Apply silicone sealant between the two pieces of flashing, spanning the splice. <br /> 3/8"to 1/2"gap,with factory- <br /> pply sealant to back leg applied bond-breaker tape to <br /> of flashing prevent 3-sided adhesion <br /> Perimeter seal <br /> E14159 or T14259 P-1144 splice,attached to <br /> flashing on one side only <br /> Shim(not by <br /> Splicing two pieces of flashing Tubelite) <br /> s y-�e <br /> LJ <br /> AS Sc - OfJ F,e rT �� 5Q,A cec :' ,AJ <br /> 67- -7- G2 <br /> Page 34 of 44 14000 Series—Revision December 01, 2009 <br />