Laserfiche WebLink
FireLock Rigid <br /> STYLES 009H/009/009V <br /> 40/\ <br /> 1.11 ;, o -*110101111111111 <br /> 5. JOIN PIPE/MATING COMPONENTS:Align the two grooved ends <br /> of the pipe/mating components. Insert the other pipe/mating com- <br /> ponent end into the gasket until it contacts the center leg of the 8. INSTALL REMAINING BOLT/NUT: Install the remaining bolt,and <br /> gasket. NOTE: Make sure no portion of the gasket extends into the thread the nut finger-tight onto the bolt. NOTE: Make sure the oval <br /> groove of either pipe/mating component. necks of the bolts seat properly in the bolt holes. <br /> 9. TIGHTEN NUTS: Follow steps 5 and 6 on pages 2 and 3 to com- <br /> plete the assembly. <br /> HELPFUL,INFORMATION <br /> Nut Socket <br /> Size Size Slze <br /> Actual Pipe <br /> Nominal Size Outside Diameter inches/ inches/ <br /> inches inches/mm Metric Metric <br /> a_. 11/4 4 1.660-4.500 % <br /> 42.4-114.3 M10 17 <br /> IMPACT WRENCH USAGE GUIDELINES <br /> • Nuts must be tightened evenly by alternating sides until metal- <br /> to-metal contact occurs at the bolt pads. For angled bolt-pad <br /> 6. ASSEMBLE HOUSINGS: Insert one bolt into the housings,and couplings, even offsets must be present at the bolts pads to <br /> thread the nut loosely onto the bolt to allow for the"swing-over" obtain pipe-joint rigidity. <br /> feature,as shown above. NOTE:The nut should be backed off no <br /> further than flush with the end of the bolt. • DO NOT continue to use an impact wrench after the visual <br /> installation guidelines for the coupling are achieved. <br /> Failure to follow these instructions could cause gasket pinching <br /> and coupling damage, resulting in joint failure, serious personal <br /> injury,and property damage. <br /> When using an impact wrench,the speed of assembly may require extra <br /> care to ensure nuts are tightened evenly by alternating sides until proper <br /> assembly is complete. Refer to the Victaulic assembly instructions sup- <br /> �t, plied with the product. <br /> �f Impact wrenches do not provide the installer with direct"wrench feel" <br /> or torque to judge nut tightness.Since some impact wrenches are capa- <br /> ble of high output, it is important to develop a familiarity with the impact <br /> wrench to avoid damaging or fracturing bolts or coupling bolt pads <br /> e during installation. DO NOT continue to use an impact wrench after the <br /> visual installation guidelines for the coupling are achieved. <br /> Perform trial assemblies with the impact wrench and socket or torque <br /> wrenches to help determine the capability of the impact wrench. Using <br /> 7. INSTALL HOUSINGS: Using the"swing-over"feature, install the the same method, periodically check additional nuts throughout the <br /> housings over the gasket. Make sure the housings'keys engage system installation. <br /> the grooves properly on both pipes/mating components. <br /> For safe and proper use of impact wrenches,always refer to the impact <br /> wrench manufacturer's operating instructions. In addition,verify that <br /> proper impact grade sockets are being used for coupling installation. <br /> For complete contact information,visit www.victaulic.com _ <br /> 1-009H/009/009V 4079 REV C UPDATED 08/2009 Z000009000 V1ctaulic <br /> VICTAULIC IS A REGISTERED TRADEMARK OF VICTAULIC COMPANY.©2009 VICTAULIC COMPANY.ALL RIGHTS RESERVED.PRINTED IN THE USA. <br /> nnni.1innnrnnnv <br />