Laserfiche WebLink
• INSTALLATION INSTRUCTIONS I-vvI 1/l./V ivv. V <br /> t-irecock EZTM Rigid <br /> STYLES 009H/009/009V <br /> u' INSTRUCTIONS FOR RE-INSTALLATION OF <br /> I,.,, ,. --;,„ ;-1-17-1,,, . '''..:,'''',;:,I I STYLE 009H/009/009V COUPLINGS <br /> Since the coupling housings conform to the outside diameter of the <br /> a ''r:•..1:1. - pipe/mating component during an initial installation, direct installation <br /> — " of the pipe/mating components into the coupling may not be possible <br /> • tir <br /> .4} upon re-installation. If this is the case, refer to the following steps for re- <br /> installing the coupling. <br /> 1. Make sure the system is depressurized and drained completely <br /> _ before attempting to disassemble any couplings. <br /> 2. Follow steps 2—3 on page 1. <br /> BAD <br /> .:' . z <br /> ,4f2,..!;;..,,,,...' ''''''''''':::::,,il, <br /> w- 3. FOR RE-INSTALLATION OF STYLE 009H/009/009V <br /> COUPLINGS, LUBRICATE GASKET:Apply a thin coat of <br /> Victaulic lubricant or silicone lubricant to the gasket sealing lips <br /> and exterior. NOTE: GASKETS FOR 009H COUPLINGS ARE <br /> NOT INTERCHANGEABLE WITH GASKETS FOR 009/009V <br /> COUPLINGS. <br /> s -;',-- <br /> 6. Visually inspect the bolt pads at each joint to ensure metal-to- ,�- �'Ws , <br /> metal contact is achieved. 1 " r <br /> t .1---",r41117•1 <br /> NOTICE <br /> • <br /> Visual inspection of each joint is critical. Improperly assembled <br /> joints must be corrected before the system is plHaced in service. j f./ <br /> GOOD BAD r I Pipe End <br /> ,,, <br /> 1 <br /> Center Leg <br /> ,,,_ H # of Gasket <br /> 4. INSTALL GASKET: Insert the grooved end of a pipe/mating corn- <br /> PROPERLY PROPERLY IMPROPERLY IMPROPERLY ponent into the gasket until it contacts the center leg of the gasket. <br /> ASSEMBLED ASSEMBLED ASSEMBLED ASSEMBLED <br /> JOINT JOINT JOINT JOINT <br /> POSITIVE OFFSET NEUTRAL OFFSET NEGATIVE BOLT PAD <br /> WITH BOLT PAD WITH BOLT PAD OFFSET GAP <br /> CONTACT CONTACT <br /> Drawings are exaggerated for clarity <br /> • "Negative"bolt pad offsets can occur when the nuts are not <br /> tightened evenly, which produces over-tightening of one side and <br /> under-tightening of the other side. In addition, "negative"offsets <br /> can occur if both nuts are under-tightened. <br /> www.victaulic.com <br /> VICTAULIC ISA REGISTERED TRADEMARK OF VICTAULIC COMPANY.©2009 VICTAULIC COMPANY.ALL RIGHTS RESERVED.PRINTED IN THE USA. �CtaUI7Cs <br />