2016-00189 - plumbing - Laserfiche WebLink

Home Browse Search

4�3 iafayette Road N. � MINNESOTA DEPARTMENT OF (651) 284-5005 St. Paul, Mingesota 55155 �BOR & Il`IDUSTRY 1-800-342-5354 www.dli.mn. ov � Division of Construction Codes and Licensing �� 'G�� REPORT ON PLANS � Plans and specifications on plumbing: Spring Hill Golf Club Training Facility, 725 County Road 6, Orono, Hennepin County, Minnesota, Plan No. PLB1601-00101 OWNERSHIP: Spring Hill Golf Club, 725 County Road 6, Orono, MN 55391 SUBMITTER: Haussner Plumbing LLC, 10520 Stonebridge Trail N, Stillwater, MN 55082 Reviewed f�r Cc�e Plans Dated: �a�'j 5 , -�j�/� �' 2'� iiance C�tY of Oro� C� a� ComP� � 1� Date Received: January 15, 2016 � � �� y p�� / � Date Approved: January 27, 2016��J�� y RevieWOr c � SCOPE: This review is limited to the provisions of the Minnesota Plumbing Code, as amended. The review is based upon the supposition that the data on which the design is based are correct. Approval is contingent upon requirements included in this report. A copy of the approved plans, specifications,and this Report on Plans must be retained at the project location for future reference. INSPECTIONS: All plumbing installations must be tested and inspected in accordance with the requirements of the Minnesota Plumbing Code. No plumbing work may be covered prior to completing the required tests and inspections. The contractor/installer must obtain an inspection permit from the Minnesota Department of Labor and Industry when an installation is for a state owned facility, Minnesota Department of Health licensed healthcare facility, or a project in an area where there is no local administrative authority. To schedule inspections, contact the state plumbing standards representative for your region. For your regional inspector's contact information,visit our website at http://www.dli.mn.gov/CCLD/CCLDContactus.asp REQUIREMENT(S): L The distance from the trap to the vent may not exceed the values given in Minnesota Rules, part 4715.2620, subpart 4. The maximum distance to a vent for the 1-1/2 inch lavatory trap is 3 feet 6 inches. 2. A water heater with a maximum tank capacity of 6 gallons or less may be concealed in a ceiling space provided the water heater has been set in an overflow pan. The overflow pan must be constructed of a corrosion resistant material, have side walls extending at least 4 inches upward, and have an outlet size that is not less than the size of the supply line to the water heater. The outlet must continue undiminished in size to a point of safe disposal below the ceiling area. Tools must not be required to gain access to the water heater (see Minnesota Rules, part 4715.2240). 3. Equipment used for heating water or storing hot water shall be protected by approved safety devices in accardance with Minnesota Rules, part 4715.2210 and part 4715.2230. It is recommended that the relief valve discharge pipe be routed independently to a point of safe disposal below the ceiling. Please note, a relief valves direct connection to a fixtures waste or vent piping is not an appropriate place of disposal. 4. Valves shall be installed permitting the water supply to each room or individual fixture to be shut off without disrupting any other portion of the building(see Minnesota Rules, part 4715.1800, subpart 6). 5. Pipe hangers and supports shall comply with Minnesota Rules, part 4715.1430. This information can be provided to you in alternative formats(Braille,large print or audio). An Equal Opportunity Employer