2011-00189 - plumbing - Laserfiche WebLink

Home Browse Search

� � . 443 Lafayette Road N. � MINNE�C�TA DEPARTMENT OF' (651)284-5005 St. Paul, Minnesota 55155 1-800-DIAL-DLI www.dli.mn.gov L.,,�� TTY: (651)297-4198 �.; Division of Construction Codes and Licensing REPORT ON PLANS Plans and specifications on plumbing:O'Reilly Auto Parts, 3424 Shoreline Dr,Orono,Hennepin County, Minnesota,Plan No.PLB 1104-00015 OWNERSHIP: O'Reilly Auto Parts,233 Patterson Avenue S, Springfield,MO 65802 SUBMITTER(S): J Berd Mechanical Contractors Inc., 3308 Southway Dr, St. Cloud,MN 56301 Plans Dated: Response Letter from Casco Apri18,2011; Revised Sheet No.P1 Apri18,2011 Date Received: April 15,2011,April 13,2011, April 1,2011 Date Reviewed: April 15,2011 SCOPE: This review is limited to the design of this particular project only insofar as the provisions of the Minnesota Plumbing Code,as amended,apply,and does not cover the water supply or sewerage system to which this plumbing system is connected. The review is based upon the supposition that the data on which the design is based are conect, and that necessary legal authority has been obtained to construct the project. The responsibility for the design of structural features and the efficiency of equipment must be taken by the project designer. Approval is contingent upon satisfactory disposition of any requirements included in this report. Special care should be taken to insure that the material and installation of the plumbing system are in accordance with the provisions of the Minnesota Plumbing Code. A copy of the approved plans,specifications,and this Report on Plans must be retained at the project location for future reference. INSPECTIONS: All plumbing installations must be tested and inspected in accordance with the requirements of the Minnesota Plumbing Code. As specified in Minnesota Rules,part 4715.2830,no plumbing work may be covered prior to completing the required tests and inspections. Provisions must be made for applying an air test at the time of the roughing-in inspection as outlined in Minnesota Rules,part 4715.2820,subpart 2,of the code. A manometer test,as specified in Minnesota Rules,part 4715.2820,subpart 3,is required at the time of the finished plumbing inspection. It is the responsibility of the contractor/installer to notify the Minnesota Department of Labor and Industry when an installation for a state contract job,Minnesota Department of Health licensed healthcare facility,or project in an area where there is no local administrative authority is ready for an inspection and test. To schedule inspections,contact the state plumbing standards representative for your region. For your regional inspector's contact information,visit our website at http://www.dli.mn.gov/CCLD/CCLDContactus.asp REQUIREMENT(S): 1. Verify that the existing water supply and waste systems are sized to accommodate the added fi�ures(see Minnesota Rules,part 4715.3700 and part 4715.2310). 2. Fixture vent connections must be taken off the dedicated fixture branch,rather than the main waste line as shown on the submitted waste and vent riser diagram. This information can be provided to you in altemative formats(Braille,large print or audio). An Equal Opportunity Employer