Laserfiche WebLink
Metadata
Document management portal powered by Laserfiche WebLink 9 © 1998-2015 Laserfiche. All rights reserved.
� <br /> ���.����� <br /> MINNESOTA DEPARTMENT OF LABOR AND INDUSTRY �l �'�r 2 �Zo48 <br /> Division of Construction Codes and Licensing y <br /> REPORT ON PLANS �� Q/���0 <br /> Plans and specifications on plumbing: Dr. Englund, 2455 Shadywood Road, Wayzata,Hennepin County, <br /> Minnesota, Plan No. 095623 <br /> OWNERSHIP: Erick Englund, D.D.S., 2455 Shadywood Road,Navarre, Minnesota 55392 <br /> SUBMITTER(S): Steinkraus Plumbing, Inc., 112 East Fifth Street, Suite 101, Chaska, Minnesota 55318 <br /> Plans Dated: <br /> Date Received: September 18, 2008 <br /> Date Reviewed: October 10, 2008 <br /> SCOPE: This review is limited to the design of this particular project only insofar as the provisions of the <br /> Minnesota Plumbing Code, as amended, apply, and does not cover the water supply or sewerage system to which <br /> this plumbing system is connected. The rEview is based upon the supposition that the data on which the design is <br /> based are correct, and that necessary legal authority has been obtained to construct the project. The <br /> responsibility for the design of structural features and the efficiency of equipment must be taken by the project <br /> designer. Approval is contingent upon satisfactary disposition of any requirements included in this report. <br /> Special care should be tal<en to insurc that the material and installation of the plumbing system are in accordance <br /> with the provisions of the Minnesota Plumbing Code. A copy of the approved plans and specifications should <br /> be retained at the project location for f'uture reference. <br /> A set of the identified plans and specifications is bein�rett�rned to Steinkraus Plumbing,Inc. � <br /> INSPECTIONS: All plumbing installations must be tested and inspected in accordance with the requirements of <br /> the Minnesota Plumbing Code. As specified in Minnesota Rules,part 4715.2830,no plumbing work may be <br /> covered prior to completing the required tests and inspections. Provisions must be made for applying an air test <br /> at the time of the roughing-in inspection as outlined in Minnesota Rules, part 4715.2820, subpart 2, of the code. <br /> A manometer test, as specified in Minnesota Rules, part 4715.2820, subpart 3, is required at the time of the <br /> finished plumbing inspection. It is the responsibility of the contractor/installer to notify the Minnesota <br /> Department of Labor and Industry when an installation for a state contract job, licensed facility, or project in an <br /> area where there is no local administrative autharity is ready for an inspection and test. To schedule inspections, <br /> contact the state plumbing standards representative for your region, or call Jim Peterson at 651/284-5889. <br /> REQUIREMENT(S): <br /> 1. Verify that the existing water supply and waste systems are sized to accommodate the added fixtLires (see <br /> Minnesota Rules, part 4715.3800 and part 4715.2310). <br /> 2. Changes in direction in drainage piping must be made by appropriate use of wyes and bends. Sanitary tees <br /> are not allowed where the direction of flow changes from either vertical to horizontal or horizontal to <br /> horizontal (see Minnesota Rules,part 4715.2410). <br /> 3. The plans showed that the sink in Room No. 1 ll is located below a window. Verify that the sink is vented <br /> in accordance with Minnesota Rules,part 4715.2540, subpart 2, and part 4715.2620. <br /> 4. It is recommended that a cleanout be provided where new waste and vent piping connects with existing <br /> plumbing to facilitate required testing of the new installation. <br />