Laserfiche WebLink
2.7 GLAZING GASKETS <br /> A. Sealants: <br /> 1. EPDM,ASTM C 864. <br /> 2. Silicone,ASTM C 1115. <br /> 3. Thermoplastic polyolefm rubber,ASTM C 1115. <br /> 4. Any material indicated above. <br /> B. Soft Compression Gaskets: Extruded or molded closed-cell,integral-skinned gaskets of <br /> material Indicated below,complying with ASTM C 509,Type II,black,and of profile and <br /> hardness required to maintain watertight seal: <br /> 1. EPDM. <br /> 2. Silicone. <br /> 3. Thermoplastic polyolefm rubber. <br /> 4. Any material indicated above. ' <br /> C. Available Manufacturers: Subject to compliance with requirements,manufacturers offering <br /> products that may be incorporated in the work include,but are not limited to,the following companies. <br /> D. Manufacturers: Subject to compliance with requirements. <br /> l. Lock-Strip Gaskets: <br /> a. Stanlock Div.,Griffith Rubber Mills. <br /> 2. Preformed Gaskets: <br /> a. Advanced Elastomer Systems,L.P. <br /> b. Tremco,Inc. <br /> 2.8 NIISCELLANEOUS GLAZING MATERIALS <br /> A. General: Provide products of material,size, and shape complying with referenced glazing <br /> standard, requirements of manufacturers of glass and other glazing materials involved for glazing application <br /> indicated,and with a proven record of compatibility with surfaces contacted in installation. <br /> B. Cleaners,Primers and Sealers: Type recommended by sealant or gasket manufacturer. <br /> C. Setting Blocks: Elastomeric material with a Shore A durometer hardness of 85 plus or minus 5. <br /> D. Spacers: Elastomeric blocks or continuous extrusions with a Shore A durometer hardness <br /> required by glass manufacturer to maintain glass lites in place for installation indicated. <br /> E. Edge Blocks: Elastomeric material of hazdness needed to limit glass lateral movement <br /> (side-walking). <br /> F. Plastic Foam Joint Fillers: Preformed,compressible,resilient,nonstaining,nonextruding, <br /> nonoutgassing,strips of closed-cell plastic foam of density,size,and shape to control sealant depth and otherwise <br /> contribute to produce optimum sealant performance. <br /> 2.9 FABRICATION OF GLASS AND OTHER GLAZING PRODUCTS <br /> A. Fabricate glass and other glazing products in sizes required to glaze openings indicated for <br /> Project,with edge and face clearances,edge and surface conditions,and bite complying with necommendations of <br /> product manufacturer and referenced glazing standard as required to comply with system performance <br /> requirements. <br /> PART 3-EXECUTION <br /> 3.1 EXAIVIINATION <br /> Page 5 of 8 <br />