Laserfiche WebLink
3.4 Fireplace Wall Enclosure • Framing dimensions should allow for wall covering thickness <br /> and fireplace facing materials.Adjust rough opening size as <br /> WARNING: Provide adequate clearances around air openings necessary to maintain minimum clearance requirements. <br /> into the combustion chamber. Provide adequate clearance in <br /> front of the fireplace for barrier removal, component access, • <br /> The bottom of the fireplace must be placed directly on a <br /> gas line installation,service access, etc. wood or non-combustible surface(not linoleum or carpet). <br /> If the fireplace is to be installed above floor level,a solid, <br /> NOTE: The construction of the fireplace wall enclosure must continuous platform must be constructed below the fireplace. <br /> comply with local building codes and all clearances as outlined <br /> in this manual. • Build the hearth to desired size and height. <br /> NOTE: Cold air transfer area. The fireplace wall enclosure • If masonry is to be used(optional),prepare the necessary <br /> should be constructed in a manner to prevent cold air from foundation for the masonry load.A lintel must be used over <br /> entering the room and outside walls should be insulated. the top of the appliance to support the additional weight of <br /> masonry construction. <br /> FIRE HAZARD: Do NOT install this appliance directly on <br /> carpeting, vinyl, or any other combustible material other than • <br /> If installing optional fan assembly#SP34-028,it is easier <br /> wood. to install before unit installation.Please refer to Section 9.3 <br /> #SP-028 Optional Fan Kit on page 33. <br /> -P <br /> • <br /> %*11`11 -0 <br /> o <br /> E <br /> 33Ye <br /> (876m6Am) <br /> 14' <br /> ((335Un�) <br /> i! / <br /> Figure 3.4,Framing Dimensions <br />