Laserfiche WebLink
3.0 FRAMING <br /> 3.1 Appliance Placement STAND-OFF BRACKETS AS SHIPPED <br /> Considerations -— <br /> WARNING:Due to high temperatures, the appliance should be �\ <br /> located out of traffic and away from furniture and draperies. .I ` .�� <br /> FIRE HAZARD: Do NOT install this appliance directly on � <br /> carpeting, vinyl, or any other combustible material other than <br /> • <br /> wood. <br /> I <br /> • This appliance must be installed on a level surface capable I <br /> of supporting the fireplace and venting. If possible,place the <br /> fireplace in a position where the vent terminates between two <br /> studs,eliminating the need for any additional framing. <br /> • This fireplace may be installed in a bedroom. � ' <br /> • Please be aware of the large amount of heat this fireplace will <br /> produce when determining a location. I <br /> 3.2 Stand-off Assembly and InstallationFORMED <br /> / <br /> STAND-OFF <br /> WARNING: The top stand-offs provide the 10 in (254 mm) i <br /> minimum clearance to the header. Use only non-combustible <br /> material in this area for the entire width of the fireplace. DO <br /> NOT use wood,sheetrock, et cetera,in this zone. <br /> Top stand-off brackets must be formed and attached prior to <br /> positioning fireplace into framed opening. <br /> BEND AT <br /> NOTE: If installing trim kit assembly #C46-FTK, please refer PERFORATIONS <br /> to Section 5.3 Optional Trim Kit Assembly #C46-FTK on page <br /> 21 before installing stand-offs. <br /> 1. Remove and save(4)screws securing stand-off heat shields STAND-OFF BRACKETS INSTALLED <br /> and stand-off brackets on top of the fireplace. ___ <br /> 2. Form each top stand-off bracket by bending at perforations, <br /> as shown. <br /> 3. Align the holes in the formed top stand-offs with the holes 010,1.ft.0 <br /> in the fireplace top.Secure with the(4)screws previously <br /> removed along with(4)screws located on top of thefireplace. I4. Form stand-off heat shields as shown.The flange will face upand to the back of the fireplace. <br /> 5. Align the in the stand-off heat shields with the holes in the <br /> top stand-off brackets Secure with(8)screws provided in the <br /> fireplace components packet. <br /> I <br /> STAND-OFF HEAT SHIELDS INSTALLED <br /> 444, <br /> • <br /> . <br /> I <br /> 1 <br /> 1 <br /> , . <br /> . . <br /> 1 <br /> Figure 3.1,Stand-oftAssembly and Installation l <br /> Stand-oft <br />