2016-00602 - alarm system - Laserfiche WebLink

Home Browse Search

DN-60408:D3 IPDACT-2/2UD NOTIFIER® FireWatch rm IP Series: IP Fire Alarm Communicator by Honeywell Miscellaneous General The new FireWatchTm IPDACT-2 and IPDACT-2UD are IP Communicators from NOTIFIER. These IP Communicators are UL 864 listed for signaling under Other Transmission Tech- nologies and comply with NFPA 72 requirements. Refer to the IPDACT Series Installation Document PN 53109 for more information. Both models connect to the primary and secondary communi- cation ports of the panel's DACT,converting the analog signals into digital signals at the panel for transmission to a compatible Teldat VisorALARM PLUS IP receiver at a central station.The panel operates normally during an alarm, supervisory or trou- o ble event and sends contact-ID formatted analog information ' l out of the telephone ports to the IP Communicator. The IP Communicator reformats the data into highly encrypted Ether- net UDP packets for transmission to a compatible receiver at the central station.This new listing only requires an IP connec- tion. No backup analog phone line is necessary. Customers the master username and password are correct, full duplex can still use a traditional backup phone line from the panel's communication is permitted to the panel. second phone port if desired. compatible Contact ID DACT-equipped panels, the IP NOTE:UL 864 Ninth Edition prohibits downloading to a panel with- WithCommunicators allow for faster and more economic digital out entering a local panel password. Uploading is permitted at any time without entering a password. alarm transmissions, improving response times and decreas- ing costs found with traditional analog systems. They offer Features supervised line functionality,where a central station can detect any off-line alarm panels within seconds.On the central station • Listed to UL Standard 864, Ninth Edition when used with side, a compatible VisorALARM® Plus IP receiver from the Notifier UL 864 Ninth Edition-listed panels. Teldat Corporation emulates popular receiver formats and • Eliminates the cost of two dedicated phone lines. Only the allows seamless integration into existing conventional central customer's shared IP equipment is required. station architectures. • Increases connection supervision to the central station from The benefit of an IP Communicator is that it is always on, the once-a-day test signal to once every 30-90 seconds. increasing the security and supervision of the central station • Requires no change to the existing panel configuration.The connection from once every 24 hours for a supervisory test IP Communicator connect directly to the primary and sec- signal to once every 30-90 seconds. ondary analog panel telephone ports. The IPDACT-2UD allows a programmer to upload and down- • Fast alarm transmission(less than 10 second transmission load data between the users PC and a supported fire alarm time). panel. The panel and PC can be anywhere on the world wide • Works over any type of customer-provided Ethernet 10/100 web or within a corporate intranet. Base network connection (LAN or WAN), DSL modem or The user's computer runs a program called UDPORT.exe to cable modem. capture the modem signals from PS-Tools panel programming • Data transmits over standard contact-ID protocol but is software.In UDPORT.exe the user enters the main IP address secured with the industry's highest level of encryption(AES of the VisorALARM receiver, the UDP port to use, username, 512 bit). and password. Instead of using the PC's modem,this process communicates between the IPDACT-2UD's modem at the • Supports both dynamic(DHCP)or Public and Private Static panel and the panel's own modem.While speed is still limited IP addressing. to the baud rate of the panel's modem, panel communications • Supports dual-destination IP receiver address for high are now 100%digital over IP from the remote program PC all redundancy configurations:all signals are sent to a second- the way to the remote panel installation. This eliminates any ary address should the primary become unavailable. dropouts in modem communications caused by noise or other • User programmable UDP ports for flexibility and compatibil- factors. If an alarm should occur during upload or download, ity with firewalls and other network security components. the panel is able to interrupt modem communications immedi- • Supports an optional third maintenance receiver installed at ately and transmit the alarm to the central station. the end user's facility that permits local alarm monitoring. Each IPDACT-2UD is registered in the VisorALARM Receiver Alarms are received simultaneously at both the central sta- with a unique serial number. A subscriber number must be tion and the customer's facility. A filter can be applied to entered into the subscriber number database field for each annunciate specific alarm types such as trouble-only IPDACT-2UD. This same number is entered into the sub- events. scriber telephone number field(panel to call) in PS-Tools as if • Supports upload/download using existing,familiar program- calling the panel on a telephone. If these numbers match, and ming tools. • Two supervised inputs and two outputs. DN-60408:D3•10/15/2014—Page 1 of 4