Industrial District ordinances - Laserfiche WebLink

Home Browse Search

Orono,MN Code of Ordinances Page 12 of 13 angle of 90 degrees or less. (2) Lighting adjacent property. Lighting sources shall not be permitted so as to light adjacent properly in excess of the maximum intensity. (3) Architectural/historical light fixtures. Arch itectu ra I�h istorica I light fixtures that feature globes that are not shielded or lighting of entire facade or architectural features of a building may be approved by the city council. In no case shall he light affect adjacent property in excess of the maximum intensity. (4) Light poles. All light poles shall be of a dark color Light colored light poles shall be prohibited. (5) Height of source and pole. The maximum height of the fixture and pole above the ground grade permitted for light sources is 30 feet.A light source mounted on a building shall not exceed the height of the building. In no case shall the hehght of a light source mounted on a pole or on a building exceed the height limits of the zoning district in which the use is located unless allowed by conditional use permit. (6) Intensity. No light source or combination thereof which casts light on a public street shall exceed one foot-candle (meter reading)as meas red from the right-of-way of said street nor shall any light source or combination thereof which casts light on adjacent residential property exceed four-tenths(0.4)foot candles(meter reading) as measured at the property line. (7) Location. The light source of an outdoor light fixture shall be set back a minimum of ten feet from a street right-of-way and five feet from an interior side or rear lot line. (8) Hours. The use of outdoor lighting for parking lots shall be turned off one hour after closing except for approved security lighting. (Ord. No. 32 3rd series, § 2, 3-27-2006) Sec.78-832. -Signage. (a) General provisions. All signs shall conform to the sign standards of section 78-1466 of the chapter. Signage within the I-Industrial District shall be limitedlto the following standards: Freestanding signs(Monument style only—No pylon sign. allowed): (1) No more than one double sided freestanding sign allowed per lot or per building. (2) The sign area shall not exceed 100 square feet oflspace on each side. (3) The sign shall not exceed ten feet in height. (4) Freestanding signs shall be located so as not to be visible to traffic within the Highway 12/394 corridor. Wall signs: (1) Buildings within the I-Industrial District may have(signs on any facade,whether or not such facade faces the public right-of-way.The total amount of wall signage for a building shall be limited to a square footage equal to five percent of the area of the facade or facades that face the public right-of-way. However, no individual fa ade shall have a signage area greater than five percent of that individual facade. (2) Wall signs on south-facing building facades adjac nt to the Highway 12/394 corridor shall be limited to one sign not exceeding ten square feet or each business entrance along the south- facing wall. Such signs shall not be internally lit. Directional signs: about:blank 10/8/2015