Laserfiche WebLink
29 <br /> 6.5 FIREBRICK INSTALLATION AND DAMPER OPERATION <br /> \v <br /> OPERATION OF THE APPLIANCE WITHOUT THE FIREBRICKS CAN RESULT IN EXCESSIVE EN <br /> TEMPERATURES THAT COULD DAMAGE THE APPLIANCE, CHIMNEY AND THE <br /> SURROUNDING ENCLOSURE. <br /> NOTE: Ensure fibre panels set in behind brick are in good condition before installing firebrick. If fibre panels <br /> need to be replaced, hold panels in position or place with masking tape until fire brick is installed. <br /> I <br /> • 011111111 <br /> • <br /> 11111111111111 <br /> ' Lilo <br /> 11 <br /> i <br /> —iiiiA. Tilt and install the right rear B. Install the middle and left C. Install the bottom <br /> firebrick against the wall. rear firebricks. firebricks to aid securing <br /> lofr <br /> the rear firebricks against <br /> _ the wall. <br /> 1 \ piiimILIIII <br /> 11. <br /> *.f,.- '.-.% <br /> 11% <br /> , , <br /> 1.1.11111 <br /> iliy -- ,4 <br /> • <br /> .S \ ! $ -- <br /> D. Tilt the top right firebrick D. Install the remaining top firebricks, <br /> and secure under the securing under the retaining <br /> retaining bracket. brackets. Install the andirons into <br /> the bottom firebricks. <br /> A A To close the damper,pull the damper control rod down and <br /> push it to the right. <br /> To open the damper,push the damper control rod to the left <br /> side and release. <br /> NOTE:The damper must be in the"OPEN" <br /> position when burning. <br /> I,I <br /> OP: <br /> j'II <br /> Ill <br /> t04 <br /> G111 <br /> - • • • IVIS � <br /> II• <br /> OPEN CLOSED <br /> • (0) (0) NOTES If damper becomes unthreaded it will <br /> • remaining situated in the"OPEN"position. <br /> I I W415-1642/04.15.16 <br />