Laserfiche WebLink
20 <br /> 4.5 INSTALLING FLASHING AND STORM COLLAR <br /> Remove the nails from the shingles above and to the sides of <br /> EN the chimney. Place the flashing over the chimney pipe and slide RAIN CAP <br /> underneath the sides and upper edge of the shingles. Ensure that <br /> the chimney pipe is properly centered within the flashing,giving -= CAULKING <br /> a 3/4"(19.1mm)margin all around.Fasten to the roof on the top 4 STORM COLLAR <br /> and sides. DO NOT NAIL through the lower portion of the flashing. \ <br /> Make weather-tight by sealing with caulking.Where possible,cover - - EATHER <br /> the sides and top edges of the flashing with roofing material.Apply SEALANT <br /> waterproof caulking, provided with the flashing,around the chimney, N <br /> 1"(25.4mm)above the top of the flashing and push the storm collar FLASHING <br /> down into the caulking. Insert a rain cap onto the top of the last <br /> chimney section. <br /> 88.1A <br /> 4.6 AIR COOLED CHIMNEY INSTALLATION <br /> Cn <br /> A. Install the base plate starter collar.Affix using the four <br /> screws. <br /> B. Install air housing to the appliance and connect to liner. AIR HOUSING <br /> C. Follow the chimney manufacturer's instructions for <br /> installing the chimney. <br /> NOTE: M&G DuraVent DuraChimney II is al- <br /> lowed for use on this product. <br /> Use DuraVent DuraChimney II brand of air cooled chimney. <br /> .. <br /> C <br /> 12"(305mm)Chimney Section 10DAC-12 • <br /> 48"(1219mm)Chimney Section 10DAC-48 • <br /> 36"(914mm) Chimney Section 10DAC-36 . <br /> . <br /> 15° Elbow EE <br /> Chase Top Flashing 1 <br /> Firestop/Radiation Shield 10DAC-RRS 1 <br /> ": <br /> Air Housing' NZAC1OKT ',--,; ' . <br /> Anchor Plate 10DAC-Ap AIR HOUSING • 0 <br /> *Required for DuraChimney II '-o <br /> NOTE: Follow the chimney manufacturer's instructions <br /> for installing the chimney. <br /> NOTE: Use 111kt outside air kit to connect to air housing. <br /> Maximum length of 4"(101.5 mm) liner is 20'(6 m). If 4"(102mm) <br /> greater length is required then increase the liner diameterLINER <br /> to 6"(152.4mm) L ����� <br /> W415-1642/04.15.16 <br />