Laserfiche WebLink
b. Solid sub-top to be 3/4"melamine laminated particle board,all base cabinets. <br /> C. Wall cabinet bottoms and tops to be 1"thick <br /> d. Exterior exposed wall cabinet bottoms to be melamine laminate bottom,plastic laminate top. Assembly <br /> devices to be concealed on bottom side of wall cabinets. <br /> e. Hang Rail: 3/4"thick x width of cabinet glued to backside and mechanically to end panels. <br /> 3. Cabinet Ends <br /> ra. Manufacturer's standard colored melamine laminated particle board interior side, 3/4" thick with <br /> phenolic neutral color back sheet on concealed side. Library stack end panels 1"thick. Holes drilled for <br /> adjustable shelves 1-1/4"on center. <br /> b. Exposed exterior cabinet ends to be laminated with plastic laminate. <br /> 4. Fixed and Adjustable Shelves <br /> a. Melamine laminated particle board one side. Tops of shelves to be high pressure plastic laminate,0.030" <br /> thick. Wilsonart Vertical Surface,Type 335. Leading exposed edge of shelves to be self-edged. <br /> b. Thickness: 3/4 standard shelving to 27"wide. One inch shelving 27 wide and over and on all exposed <br /> cabinet shelving regardless of width. <br /> 5. Cabinet Backs <br /> a. Standard cabinet back to be 3/8" thick,prefinished for use on all cabinets with or without doors. Rear, <br /> unexposed side of back to receive continuous hot melt glue at joint between back and sides/top/bottom <br /> for sealing against moisture and vermin,and further contribute to case rigidity. <br /> b. Exposed exterior backs to be 3/4"particle board faced with high pressure plastic laminate. <br /> 6. Doors and Drawer Fronts <br /> a. Plastic laminate hinged and sliding doors and drawer fronts to be 13/16 inch thick Core material to be <br /> 3/4" thick, 45 lb. density particle board bonded on exterior with high pressure laminate and with high <br /> pressure cabinet liner on interior face. Drawer fronts and hinged doors are to overlay the cabinet body. <br /> Maintain a maximum 1/8" reveal between pairs of doors, between door and drawer front, or between <br /> multiple drawer fronts within the cabinet. <br /> b. Exposed edges are to be 3mm PVC. <br /> 7. Drawers <br /> a. Drawer fronts shall be applied to separate drawer body component sub-front. <br /> b. Sides and back of drawers to be 1/2"thick colored fiberboard,sub-front same,to be 5/8"thick. <br /> C. Fiberboard to be of uniform density and meet the following minimum standards: <br /> Screw holding,face 355 Is. <br /> Screw holding,edge 300 lbs. <br /> Modulus of rupture 4,500 psi <br /> Modulus of elasticity @ 500,000 psi <br /> Internal bond 100 psi <br /> 06401-5 No.99132-CP2 <br />