info on fire water bowls - Laserfiche WebLink

Home Browse Search

O�i'19i2010 16;3? FAX 8�2445'96' 90UOL I�O11 Burner Adtustment Note: Each Burner should have a flame height af approximately 12"—15"from the top of the Bowl. 3.70 The height of th�fiame can be adjusted at each Burner by opening or ciosing the%z" Gas Va1ve or Keyed Valve as shown in Fig. 4. ' 3.75 Each Burner should be adjusted as required so that the flarna size at each Bowl is � similar in appeacance to each other. 3.80 After aH Burners have been adjusted, make sure that the Burner Assembly is . repositioned so that it is sitting level In each Bow1. 3.65 Install decorative rock or gkass on top of the"Burner Support" and Burner Assy. Larger lava rock is recomriended (2"-4" in size). It will work better than smaller rock. Make sure that all rock is clear of the pilot area and hoad area. Filot Haad area needs to remain clear of rock for proper ventilation. 3.90 �Vote: Do not use glass with prapane installations. (If you use glass, you wil{ need to lay down stainless screen to prevent glass from faliing through-please consult Grand Effects Glass Install Manual. (f you usell4" pieces of lava it should be treated as a gfass installation). Important: Both sides of Pifot Hood need to be clsar of rock far proper ventilation and opera4ion. Do not use Flre Glass with propane insta{lations.!! 4.0 Maintenance 4.1 Periodically clean the Bumer Assembly and Bowl with a wet cloth ��cleaning solution to remove carban build-up. 4.2 Frequency of the cleaning wilf depend on usage. 4,3 Frequently inspect the gap between the base of the Bowl and the Mounting Bracket. It should be kept free of dirt and debrls that may restrict cooling air and drainage. See {Fig. 10) 4.�F Periodically Inspect the underside of the Bumer Assembly for any signs of excessive temperatures. 4.5 Checic that all gas connections are tight. 4.6 The units should be cycled trequently (especially after a rain). The Burner Assembly will not work in snow and ice conditions. The Burner Assembly should be covered and protected from snow and ice. The Burner should not be operated in high wind conditions. High winds can lirnit the cooling air required for caoling of the Burner Assembly and cause over heating of the efectronics. Important: The System needs to be turned oNoff after a rain to remove any wa�r in the pllot area. Note: If any problems are present,consult a licensed fieating Speclallst or call Grand Effects. 9