|
� ,
<br />+ 443 Lafayette Road N. � ���,j�y,� .£"',,,,�,.(�"'["A C�EPt�►�tTl�''�Et�T �F (651)284-5005
<br /> St. Paul, Minnesota 55155 - �5�� � i�i������ TTY: (651) D97_L4-D$I
<br /> www.dli.mn.gov ; j j`�
<br /> r�k
<br /> Division of Construction Codes and Licensing
<br /> REPORT ON PLANS
<br /> Plans and specifications on plumbing: Orono Police Department, 2730 Kelley Parkway, Orono, Hennepin County,
<br /> Minnesota, Plan No. PLB 1406-00246 R
<br /> ���� � �c��VF�
<br /> OWNERSHIP: City of Orono, 2 0 Kelly Parkway, Orono, MN 55356 JU( 20
<br /> �s �4
<br /> SUBMITTER(S): City of Orono, 2750 Kelly Parkway, Orono, MN 55356 C��OF
<br /> , �R�No
<br /> Plans Dated: June 9, 2014
<br /> Date Received: J��ne 30, 2014 ,
<br /> Date Reviewed: July 9, 2014
<br /> SCOPE: This review is limited to the design of this particular project only insofar as the provisions of the
<br /> Minnesota Plumbing Code, as amended, apply, and does not cover the water supply or sewerage system to which
<br /> this plumbing system is connected. The review is based upon the supposition that the data on which the design is
<br /> based are correct, and that necessary legal authority has been obtained to construct the project. The responsibility
<br /> for the design of structural features and the efficiency of equipment must be taken by the project designer.
<br /> Approval is contingent upon satisfactory disposition of any requirements included in this report. Special care
<br /> should be taken to insure that the material and installation of the plumbing system are in accordance with the
<br /> provisions of the Minnesota Plumbing Code. A copy of the approved plans,specifications,and this Report on
<br /> Plans must be retained at the project location for future reference.
<br /> INSPECTIONS: All plumbing installations must be tested and inspected in accordance with the requirements of
<br /> the Minnesota Plumbing Code. As specified in Minnesota Rules, part 4715.2830, no plumbing work may be
<br /> covered prior to completing the required tests and inspections. Provisions must be made far applying an air test at
<br /> the time of the roughing-in inspection as outlined in Minnesota Rules, part 4715.2820, subpart 2, of the code. A
<br /> manometer test, as specified in Minnesota Rules, part 4715.2820, subpart 3, is required at the time of the finished
<br /> plumbing inspection. It is the responsibility of the contractor/installer to notify the Minnesota Department of Labor
<br /> and Industry when an installation for a state contract job, Minnesota Department of Health licensed healthcare
<br /> facility, or project in an area where there is no local administrative authority is ready for an inspectiot�and test. To
<br /> schedule inspections, contact the state plumbing standards representative for your region. For your r�gional
<br /> inspector's contact information, visit our website at http://www.dli.mn.gov/CCLD/CCLDContactus.asp
<br /> REQUIREMENT(S):
<br /> 1. All plumbing shall be installed in accardance with the Minnesota Plumbing Code(see Minnesota Rules,
<br /> part 4715.0320).
<br /> 2. Verify that the existing water supply and waste systems are sized to accommodate the added fixtures(see
<br /> Minnesota Rules, part 4715.3800 and part 4715.2310).
<br /> 3. A 3-inch minimum vent stack, continuous in size from base to terminal, must be provided for every sanitary
<br /> building sewer(see Minnesota Rules, part 4715.2520, subpart 1). This stack should be the mos�t remote from
<br /> the location where the building drain leaves the building. The 3-inch metallic vent for the flammable waste
<br /> interceptor shall not be used as a full-size vent.
<br /> This information can be provided to you in alternative formats(Braille, large print or audio). �
<br /> An Equal Opportunity Employer ,
<br />
|