Laserfiche WebLink
3.01 EXAMINATION, continued <br /> C. Do not install doors in frame openings that are not plumb or are out-of-tolerance <br /> for size or alignment. <br /> 3.02 INSTALLATION <br /> A. Install doors in accordance with manufacturer's instructions. <br /> B. Trim non-rated door width by cutting equally on both jamb edges. <br /> C. Trim door height by cutting bottom edges to a maximum of 3/4 inch (19mm). Trim <br /> fire door height at bottom edge only, in accordance with fire rated requirements. <br /> D. Machine cut for hardware. <br /> 3.03 INSTALLATION TOLERANCES <br />�� A. Conform to AWI requirements for fit and clearance tolerances. <br /> � B. Conform to AWI Section 01300 requirements for maximum diagonal distortion. <br /> 3.04 ADNSTING <br />�� A. Section 01700—Contract Close-Out: Adjusting installed work. <br /> B. Adjust door for smooth and balanced door movement. <br /> i <br /> C. Adjust closer for full closure. <br /> ,. � <br /> END OF SECTION <br /> � <br /> �.� <br />� <br />��� <br />��� <br />� <br /> � <br /> ' Division 8—Section 08211 <br /> :��� <br /> Page 3 of 3 <br />,,.� <br /> �..�, <br />