Laserfiche WebLink
r�� <br /> iJ; <br /> 1.06 EXTRA MATERIALS <br /> A. Furnish under provisions of Section 01700. <br /> B. Label each container with color, type, texture, room locations, and in addition to <br /> the manufacturer's label. <br /> PART 2 PRODUCTS <br /> 2.01 MANUFACTURERS <br /> A. Manufacturers -Paint <br /> 1. Pratt and Lambert, Sherwin Williams, Pittsburgh, or approved equal. <br /> 2. <br /> 02 MATERIALS � <br /> A. Coatings: Ready mixed, except field catalyzed coatings. Process pigments to a soft <br /> paste consistency, capable of being readily and uniformly dispersed to a � <br /> homogeneous coating; good flow and brushing properties; capable of drying or <br /> curing free of streaks or sags. <br /> B. Accessory Materials: Linseed oil, shellac, turpentine, paint thinners and other � <br /> materials not specifically indicated but required to achieve the finishes specified, of <br /> commercial quality. c� <br /> C. Patching Materials: Latex filler. <br /> PART 3 EXECUTION �� <br /> 3.01 EXAMINATION <br /> A. Verify site conditions under provisions of Section 01100. � <br /> B. Verify that surfaces are ready to receive work as instructed by the product <br /> manufacturer. <br /> C. Examine surfaces scheduled to be finished prior to commencement of work. � <br /> Report any condition that may potentially affect proper application. <br /> D. Test shop applied primer for compatibility with subsequent cover materials. <br /> �. Measure moisture content of surfaces using an electronic moisture meter. Do not <br /> apply finishes unless moisture content of surfaces are below the following <br /> maximums: <br /> 1. Plaster and Gypsum Wallboard: 12 percent. <br /> 2. Masonry, Concrete, and Concrete Unit Masonry: 12 percent. <br /> 3. Interior Wood: 15 percent, measured in accordance with ASTM D2016. <br /> 4. Exterior Wood: 15 percent, measured in accordance with ASTM D2016. <br /> � <br /> � <br /> Division 9—Section 09900 <br /> Page 2 of 5 �' <br /> ,� <br />