2005-P08908 - septic - Laserfiche WebLink

Home Browse Search

s + A pumping chamber will need to be installed to lift the effiuent to the treatment area. The power supply and switches must be located outside the manhole and pumping chamber in a weather proof enctosure. A warning device must be installed with a tight and sound device, this is in case of a pump failure. . , The manifold and supply line pipe must have back drainage to the pumping chamber. The distribution pipes shaff have their ends capped. Be sure the rock and sand fifl material are clean. The sod layer below the entire mounded area must be turned over, just break up the sod, be gure not to over work. All neighboring wells are located greater than 100' away from the proposed treatment area. Keep all heavy equipment off of the proposed treatment area before and after construction. The treatment area should be marked off before construction. This Design is not valid �the system will need to be relocated if failure to protect the areas proposed for On-Site Sewage Treatment occurs. With proper installation and maintenance, this system should have no problem in treating septic effluent efFectively. Nothing other than human waste, toilet tissue, laundry, showers, water softener etc. should be disposed of into the septic tanks. Recommend Iron filters be diverted out of the system. Recommend to divert the water softner atso if the iron filter is diverted. Garbage disposals are not recommended, due to adding more solids &fine solids passing through to the system. Excessive amounts of soaps, antibacterial soaps, cleaning agents, shower cleaners used every shower&chlorine agents may kill the bacteria needed to treat septic effluent. Additives are not �ecommended. Recommend to pump & clean your tanks through the manhole by a certified pumper every 2 years. Check with your pumper to set up a schedule. Recommend laundering be limited to 3 to 4 loads per day. C��- ��... Steven B. Schirmers 2